FUSE
FUSE
230
051101
50/60Hz
MAINS SUPPLY
AC
40 WATTS
RISK OF
ELECTRIC SHOCK
DO NOT OPEN
RISQUE DE CHOC
NE PAS ENLEVER
CAUTION ATTENTION
ALWAYS
REPLACE
WITH SAME
FUSE TYPE:
230V T250mA
115V T500mA
REMOTE
WARNING
THIS EQUIPMENT MUST BE EARTHED
DO NOT EXPOSE TO RAIN OR MOISTURE
SPEAKERS CONSOLE INTERFACE STEREO RECORD/PLAY
SURROUND RECORD B
SURROUND RECORD A
SURROUND PLAY B SURROUND PLAY A SURROUND BUS INPUTS
DECODER
ENCODER
LCRS
LCRS LtRt
LtRt
LtRt RECORD/PLAYBACK
LCRS AND STEREO MIXES FROM CONSOLE
LCRS RECORD
LCRS PLAY
2 TRACK TAPE B RECORD/PLAYBACK
2 TRACK TAPE A RECORD/PLAYBACK
SURROUND A RECORD/PLAY
SURROUND B RECORD/PLAY
TO POWER AMPS/SPEAKERS
CONSOLE CONTROL ROOM AND GUIDE
OUTPUT SIGNALS, SOLO AND TALKBACK LOGIC
SURROUND AND STEREO MIXES FROM CONSOLE
ENCODER SEND/RETURN
DECODER SEND/RETURN
LtRt RECORD/PLAYBACK
MULTITRACK RECORDER B
MULTITRACK RECORDER A
TWO TRACK RECORDER B
TWO TRACK RECORDER A
LIVE SOURCES
24 TRACK RECORDER(S)
Dolby SDU4 DECODER Dolby SEU4 ENCODER
5.1 MIX FROM CONSOLE
5.1 RECORD
5.1 PLAY
MULTI FORMAT MIXING
APPLICATION NOTES
510
ANALOGUE SIGNAL PROCESSING
The versatility of the ASP510 makes it
possible to assemble simultaneous 5.1 and
LCRS masters while also producing and
monitoring an LtRt encoded output.
The 5.1 mix derived from the mixing
console is routed directly to Multitrack
Recorder B whose play output is connected
to the ASP510 SURROUND PLAY B port.
This recorder can be monitored by
depressing the SURROUND PLAY B
source selection switch (record/playback
switching is then performed by the
recorder).
The LCRS mix from the console is
connected to the ASP510 via its
SURROUND BUS port with the LCRS
recorder interfaced via the
SURROUND A RECORD and PLAY ports,
monitoring is via the SURROUND A
RECORD AND PLAY monitor source
selection switches.
Dolby Surround encoders and decoders
are connected to the ASP510 ENCODER
and DECODER connectors. With the
STEREO RECORD SOURCE set to
ENCODER both 2 track machines are fed
with the encoded LtRt mix. The two track
machines can be monitored using the
STEREO RECORD and PLAY A/B source
selection switches. By depressing the
ASP510 ENCODER/DECODER insert
switch the LtRt mix can be decoded back
to LCRS prior to monitoring.
If a Dolby Surround encoded output is not
required a simple downmix of the LCRS
source may be output to the 2 track
machines by selecting DOWNMIX as the
STEREO RECORD SOURCE.
Compatibility checks are possible at all
times using the MONITOR FORMAT
selection switches.
LCR
LS
L alt
SUB RS
R alt
ASP
510
SURROUND CONTROLLER
BYPASS LCRS STE MNO
BUS ENC O/P
SURROUND
STEREO ENCODER/
DECODER
MONITOR SOURCE
STEREO RECORD SOURCE
MONITOR FORMAT
010
ISOLATE
GUIDE MODE
VOLUME
ASP
510
SURROUND CONTROLLER
CUT
REF
DIR
PLAY
A
PLAY
1
PLAY
B
PLAY
2
SUB
Rs
R
L
Ls
C
/