poly-planar CMR-60 Supplemental Instructions

  • I have reviewed the provided document, which contains instructions for the IMR-2 wired remote and the CMR-P pull up resistor from Poly-Planar. The document describes when the resistor is required with longer cable lengths and how to properly connect it. I'm ready to answer your questions about this document and the devices it describes.
  • When is a pull up resistor needed for MRD-60?
    What is the model number of the pull up resistor?
    Where should the CMR-P be attached?
    Is the pull up resistor needed for all connections?
520 McCormick Drive, Suite F, Glen Burnie, MD 21061 Phone: 410 761-4000 Fax: 410 761-6274 www.polyplanar.com
IMR- 2 Wired Remote
Supplement Instructions for CMR-60 extension cables.
The MRD-60 requires a pull up resistor when using the
MRR7 with 60 Ft., or more, extension cable length.
A Pull up resistor Poly Planar # CMR-P is available for
the Expansion Port Ribbon Connector
Attach the CMR-P to the IMR-2 interface ribbon cable.
Be sure the unit is fully seated and the latches are
closed.
This device is not needed on connections under 60 Ft.
/