ALPATEC PRMD 2000 User manual

ALPATEC
Brand
ALPATEC
Model
PRMD 2000
Type
User manual

This manual is also suitable for

MODE D’EMPLOI
USER MANUAL
PANNEAU RAYONNANT MICA
MICA PANEL HEATER
PRMD 1000 - PRMD 1500 - PRMD 2000
PRMD_notice: notice_PC461/462 4/06/08 14:36 Page 1
Page is loading ...
Page is loading ...
Page is loading ...
Read all these instructions carefully before using this product.
• Make sure that the voltage rating on the type plate corresponds to your main voltage. If not, see your
retailer and do not connect the appliance.
• Keep out of children or incompetent persons and do not allow them to operate this appliance.
• Only use the appliance for domestic purposes and in the way indicated in these instructions.
• From time to time, check the cord for damages. Never use the appliance if cord or appliance show
any sign of damage.
• Never place the appliance under any electrical connector.
• Make sure that the connection cord does not touch any hot surface.
• Keep combustible materials such as drapes, clothing, towels away from the appliance.
• Do not cover the appliance.
• Keep the appliance at least 1 meter away from walls and any other thing, to permit a good air
circulation.
• Never immerse the product in water or any liquid for any reasons. Do not use it at less than 60 cm of
a shower, a bath-tub or a swimming-pool.
• Do not use the appliance outdoor.
• Do not use if you have wet hands.
• Never use the appliance on or near hot surfaces.
• Never move or range the appliance by pulling the cord.
• To avoid any risk of burn, never move the appliance when it is hot.
• Before tidying the appliance, make sure that it is unplugged from the power and that it is completely
cooled.
• Unplug the appliance before cleaning.
• Do not clean the appliance with abrasive chemicals.
• Do introduce neither metallic objects, nor fingers inside the appliance in order to protect you from
electrical shock.
• Never use accessories that are not recommended or supplied by the manufacturer. It could
constitute a danger to the user and risk to damage the appliance.
• All interventions made by a non-qualified person can be dangerous; in this case guarantee conditions
would cancel. As all electrical products, a competent electrician must repair it.
THE MANUFACTURER WILL NOT ASSUME ANY RESPONSIBILITY IN CASE OF NON ADHERENCE
TO THIS RECOMMENDATION
SAVE THESE INSTRUCTIONS CAREFULLY
5
ENGLISH
ALPATEC thanks you for buying this product and hope you will be totally
satisfy with it. For your comfort and security all the steps of the manufacturing
have been checked and the product succeeded in all our quality tests.
ALPATEC’s products : their design and facility of use make you like them.
CAUTION
PRMD_notice: notice_PC461/462 4/06/08 14:36 Page 5
Models PRMD 1000 PRMD 1500 PRMD 2000
Volt 230 V 230 V 230 V
Power max 1000 W 1500 W 2000 W
Power low - 1000 W 1500 W
1-Running light indicator
2-Power switch and level selector knob
3-Thermostat
4-Feet with casters
5-Grid
6-Built-in handle
7-Wall mounting hole
8-Wall mounting support
This appliance can be used in bathroom (degree of protection IP 24).
6
SPECIFICATIONS
DESCRIPTION OF APPLIANCE
1
2
3
4
5
6
7
8
PRMD_notice: notice_PC461/462 4/06/08 14:36 Page 6
7
On the floor :
• Fix the two casters on each side
of the heater as shown.
• Fix the casters with screw.
On the wall :
• Mark first screw hole on the wall (about 80 cm from floor).
• Drill first hole, then insert first screw anchor into the first hole with a
hammer.
• Put mounting support on the wall and tighten lightly the first screw.
• Mark second hole on the wall by raising the support in parallel to the
floor.
• Drill second screw into the second hole and insert the screw anchor.
• Tighten both screws.
• Fix the feet cover.
• Place the mounting holes of the support at level of screws. The
appliance is fixed.
• Cut the plug from the power cord and connect according to the legislation into force.
• Plug the appliance.
• Turn the power switch (2) on desired position :
position I = 1000 W for model PRMD 1000
position I = 1000 W or position II = 1500 W for model PRMD 1500
position I = 1200 W or position II = 2000 W for model PRMD 2000
• Turn the thermostat (3) to select desired temperature.
• When desired temperature is reached, heater stops automatically.
• If ambient temperature decreases, heater restarts automatically.
• According to personnal needs, temperature can be increased or decreased with the thermostat.
• Anti-frost function keeps the surrounding temperature above “freezing point”.
To do this, turn the thermostat to the mark.
The appliance is equipped with an automatic cut-off device in case of overheating.
• Before any cleaning or maintenance operation, switch off and unplug the appliance.
Ensure it is perfectly cooled.
• To remove the dust, wipe your appliance with a dry cloth.
• Never use abrasives or detergents.
INSTALLATION
OPERATING INSTRUCTIONS
MAINTENANCE
PRMD_notice: notice_PC461/462 4/06/08 14:36 Page 7
Page is loading ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

ALPATEC PRMD 2000 User manual

ALPATEC
Brand
ALPATEC
Model
PRMD 2000
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents