19
Step 4 (Carts assembly)
a) Loosen the two pre-installed bolts on left side
of body assembly (A) and allow 1/4 bolt’s
length to extend from the body assembly.
b) Align the two holes on the left cart panel (C)
with the two bolts extended from the body
assembly (A).
c) Align the four holes on the left cart panel (C)
with the four holes on the left cart bottom
panel (E).
d) Insert one M6 x 15mm bolt (AA), one M6 flat
washer (BB) and one M6 spring washer (CC)
into each pre-drilled hole. Tighten bolts by
hand until secured.
e) Repeat the same procedure on the right cart
panel (M) with the right cart bottom panel (N).
f) Go back and tighten all bolts using the
screwdriver provided.
AA X8
CC X8
BB X8
Pre installed Bolt X4-()
C
M
Pre ins talle d Bo lt X4-()
AA X10
CC X10
BB X10
T
B
Step 5 (Side shelves assembly)
a) Loosen the two pre-installed bolts on left
side of body assembly (A) and allow
1/4 bolt’s length to extend from the body
assembly.
b) Align the two holes on the left side shelf (B)
with the two bolts extended from the body
assembly.
c) Align the four holes on the left cart panel (C)
with the four holes on the left side shelf (B).
d) Insert one M6 x 15mm bolt (AA), one M6
flat washer (BB) and one M6 spring washer
(CC) into each pre-drilled hole. Tighten bolts
by hand until secured.
e) Repeat the same procedure on the right cart
panel (M) with the right side shelf (T).
f) Go back and tighten all bolts using the
screwdriver provided.