FFAS1411-601501BF0

American Standard FFAS1411-601501BF0 Installation & Operation Instructions

  • Hello! I am an AI chatbot trained to assist you with the American Standard FFAS1411-601501BF0 Installation & Operation Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Rev. FF1-CN521K00036799/A0
- 1 -
- 4 -
FFAS1411-601501BF0
Hand Spray
Single Lever Exposed Bath & Shower Mixer
(W/O Shower Hose and )
FFAS1412-701501BF0
Hand Spray
Single Lever Exposed Shower Only
(W/O Shower Hose and )
FFAS1411-601501BF0
Installation &
Operation Instructions
Dimension
Recommended Tools and Materials
* Recommended water pressure condition: 0.1~0.5Mpa.
* Environment Temperature:1~55
* Steam is not allowed to use.
* The cold and hot water pipes must not be reserved.
Conditions for use
*Remove all impurity in pipes before beginning to avoid clogging. Connect faucet pipes correctly.
* Check installation distances in the Dimension diagram to ensure correct installation.
Make sure the cold water hose
is connected to the right side and the hot water hose to the left.
When in the process of installation, grab the whole body. Do not grab handle only.
Pre-Installation Checks
* American Standard always keep raising and improving the product design and performance, and reserve the right to modify
the dimension and spefication. At this case, we will not inform you separately.
* This installation instruction sheet is for your reference only, the dimension and specification is subject to the actual products.
Thank you for selecting American-Standard - the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin.
All instruction procedures must comply in strict accordance with applicable local plumbing and building codes
Pencil
windtight swathe
Adjustable Wrench
Level
Tape Measure
1
2
Test / Usage
* Move handle down into “OFF”position. Turn on supply angle valve to check all connections for leak.
* Operate handle up and down, left and right to flush water lines thoroughly.
Test
Usage
Trouble Shooting Guide
Untwist the hose.
Cartridge packing
Hose junction
Check the connection.
Check cartridge install.
Check valve position.
Check any impurities.
Remove all impurities.
Open it to full valve
When packing is damaged, replace the cartridge.
Check the existence of packing and wind it up sufficiently
Poor flow rate
Leakage
Water supply valve
Flexible hose
Aerator
Check if hose is twisted.
Check if the water from Supply valve is enough or not
Check if the supply pipe connected correct or not
Connect the hot and cold water pipe correctly
Increase water supply
Deviant
Temperature
Supply Valve
Trouble
Checkpoint
Contents
Action
Supply system
Care & Maintenance
Aerator
clean Water
Remove all impurity in Aerator
Soft Brush
Concept
Concept
G 1/2"
135~165
178
70
G 1/2"
52
140
G 1/2"
135~165
70
G 1/2"
141
97
A
B
1
2
3
4
5
2
.5
Cold
Hot
ON
Cold
Hot
ON
Attention:
Please leave the manual with the customer
after installation is finished.
* If you want to do the maintenance
for the faucet, please follow the
below process.
FFAS1412-701501BF0
FFAS1411-601501BF0 FFAS1412-701501BF0
Unit:mm
- 2 -
- 3 -
Installation
Installing the S-Connector
1
1
Installing the Faucet
2
35~40
1
50
2
(Cold)
(Hot)
S-Connector
Finished Wall
Escutcheon
Washer
Nut
Faucet
2
1
3
30
S-Connector
Water Supply
Pipeline(Hot)
Water Supply
Pipeline(Cold)
Parts List
* Consult the dimension drawing and lay the pipes.
* Wash and clean the water supply pipeline.
Parts List
No. Part Name Q’ty
1
2
3
4
5
6
7
7a
8
Index Button
Handle
Screw
Cap
Nut
Cartridge
Body(1411)
Body(1412)
Diverter
1
1
1
1
1
1
1
0
1
9
10
11
12
13
14
15
Aerator
Screw
O-Ring
Nut
Escutcheon
S-Connector
Washer
FFAS1411 / FFAS14 12
1
1
1
1
1
1
0
1
0
1
2
2
2
2
2
2
0
2
2
2
2
2
2
9
8
3
1
2
4
5
6
7
11
10
15
12
13
14
7a
Connect Shower
No. Part Name Q’ty
4
FFAS1411 / FFAS14 12
Level
/