2. Warrior Products
  3. 897

Warrior Products 897, WAR1786 Installation guide

  • Hello! I have reviewed the Installation Instructions for the Warrior Products Steering Box Brace model 895/897. This document provides a step-by-step guide to install the product, including how to attach it to the frame and steering bracket, ensure Pitman Arm clearance and correct torque specifications. I am ready to answer your questions about the installation process and the product itself.
  • What should be removed first?
    What is the torque for the bolts on the frame?
    What is the torque for the bolts around the steering box?
.
.
.
.
.
.
.
.
.
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Warrior Products, Inc.
STEERING BOX BRACE
INSTALLATION INSTRUCTIONS
WAR 895/897
1. Remove the rear bolt from the spring hanger on the passenger side .
2. Bolt the cross bar steering brace to the frame rail with the bolts provided. Use one of
the 1 ½” bolts through the existing frame bracket, (bolt, lock washer, and flat washer).
Use one of the 1 ¼” bolts through the frame’s existing hole, (bolt, lock washer, and flat
washer). Do not tighten at this time.
3. Install “C” brackets around the bottom of the steering bracket using the bolts and lock
nuts provided. Make sure the Pitman Arm has clearance to turn without interference
from the bracket.
4. Torque bolts on the frame first to 50 ft lbs. Then torque bolts around the steering box
to 50 ft lbs.
5. After a test drive, verify that all of the bolts are tight.
HAPPY 4 WHEELIN’ !
Warrior Products, Inc.
11100 SW Industrial Way
Tualatin, Oregon 97062
(503) 691-8915
(503) 692-0364 FAX
(888) 220-6861 Toll Free
wp@ warriorproducts.com
“Your Knight in Shining Armor!”
/