ALPHA 8A
User’s Manual
Kullanma Kılavuzu
English
DMX-512 SPLITTER
2
www.sspworld.com
Congratulations on purchasing your new DMX distributor. The unit has two input and two level output
Absolutely electric isolation between input and output or between output and output. Two type DMX
connector 3pin for each individual channel, each DMX output features a independent driver. We strongly
Recommend that you take time to read read this manual fully before you attempt to use DMX distributor.
1. Technical specication
Power input.................AC230V 50Hz/60Hz
AC230V 50Hz/60Hz
Dimension...................482 x 178 x 52mm
Weight.........................3Kg
2.Operating Instruction
Complete Electrical isolation
DMX output: connect to the DMX receiving device
DMX input: from the DMX transmitting device
twleve
482 X 178 X 52MM
twleve
482 X 178 X 52MM
1=Ground
2=Data -
3=Data +
Connector pin designations shall be as follows;
pin1: signal common (shield)
pin2: dimmer drive complement (data1-)
pin3: dimmer drive true (data 1+)
3
www.sspworld.com
twleve
482 X 178 X 52MM
Receiver can not more than 32 units on one out channel.
Use one terminator on the test receiver
Caution:
This apperatus must be earthed.
Do not apply power source before completely installation.
Always disconnect from mains before replacing the fuse.
To reduce risk of re electrical shock do not expose to rain or moisture.
Do not try repair it when the circuit is out of order. Send it back to your supplier for repairing.
4
www.sspworld.com
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
SHOWTEC Polar 340 WashFX User manual
-
Enttec DMXIS Quick start guide
-
-
LSC E24 User manual
-
-
Briteq BT-THEATRE HD2 Owner's manual
-
-
Chauvet DMX Mega Strobe II User manual
-
-
