15
Switching to andby mode
You have following options to switch your device into
andby mode:
● via remote control or smartphone app
● via rocker switch.
Turning on or o:
Press and hold the rocker switch for several seconds.
Refer to section "Controls" for the settings of the
rocker switch.
Standby mode mutes the device. When you leave
andby mode, the previously used volume and hearing
program are set.
Note:
● In andby mode, the device is not turned o
completely. It draws some power. Therefore, we
recommend to use andby mode only for a short
period of time.
● If you want to leave andby mode, but the remote
control or app is not at hand, turn your device o
and on again (by opening and closing the battery
compartment). In this case, the default volume and
hearing program are set.
CROS Pure 312 AX [EN].indd 15CROS Pure 312 AX [EN].indd 15 12-10-2021 11:38:2812-10-2021 11:38:28