CAUTION: This fixture is designed for permanent installation in ordinary (Non-Hazardous) locations in accordance with the National Electrical Code and

all applicable local codes. Do not use in areas of limited ventilation or in high ambient enclosures. The lamp and fixture operate at high temperatures.

Contact with combustible materials can cause fire and personal contact can cause severe burns.

FSX WET FLUXSTREAM

WIREGUARD

INSTRUCTIONS

Page 1 of 1

ATTENTION: Ce luminaire a t conu pour une installation permanente dans un emplacement rgulier (non dangereux) et en conformit avec le

Code lectrique canadien et codes locaux applicables. Ne jamais installer dans un endroit o la ventilation est limite ou dans des botiers o la

LECTRICIEN QUALIFI OU SERVICE PERSONNEL

CAUTION: THE INSTALLATION AND SERVICING OF

THIS PRODUCT SHOULD BE PERFORMED BY A

QUALIFIED ELECTRICIAN OR SERVICE PERSONNEL

Signify Corporation North

200 Franklin Square Drive

Somerset, NJ 08873

Phone: 855-486-2216

1. Mount (4) Nylon Clamps on Wireguard at the (4)

approximate locations shown in Fig. 1.

1. Monter (4) les Serre - Cbles en Nylon sur le Protge-fil

au (4) lieux approximatifs indiqus  la Figue. 1.

FIGURE 1

FIGURE 2

FIGURE 3

2. Position bracket over housing by spreading

the bracket open at the ends. When bracket is

placed over housing, squeeze bracket so that

SCREW

VIS

SCREW

VIS