Swurfer SWBKT Operating instructions

WARNING: Regularly check your swing-set and conversion bracket for tight secure ﬁt.

Attach swings and accessories following manufacturers instructions.

@TheSwurfer Swurfer.com

Distributed by

Swurfer Swing Set conversion Bracket

installation instructions:

1. Loosen up the screws on the angle brackets so that you are able to slip em’ around.

2. Get that bracket on the swing beam!

3. Mark beam where hole in bracket is and drill through the beam with 1/2” drill bit.

4. Shimmy the bolt on through the bracket and the beam.

5. Slide the angle bracket so that they are lined up nice with the beam!

6. Throw on that washer and lock nut!

7. Make sure they’re nice and tight and ready to Swurf!

*Tensile Strength 150 LB

Visit www.swurfer.com

SW-BRKT-GR

SW-BRKT-BR