Wildix W04FXO Quick Installation Manual

Brand: Wildix

Model: W04FXO

Type: Quick Installation Manual

W04FXO 2020 Quick Installation Guide

Page 2 of 3

5 - FXO 1-4 LED indicators

6 - Power indicator: shows power supply status

7 - Running indicator: indicates network registration status

8 - Reset button

LED indicators description

Indicator Definition Status Description

PWR Power indicator On The device is powered on

Off There is no power supply or power supply is abnormal

RUN Running indicator Slow

flashing

The device is running properly

Fast

flashing

SIP registration is successful

Off The device is running improperly

FXO 1-4 FXO In-use

indicators

On FXO port is currently occupied by a call

Off FXO port is idle or faulty

WAN/PoE/

LAN

Network indicators Green

flashing

The device is properly connected to network

Off The device is not connected to network or the connection

is improper

Installation and network connection

Connect network cable to WAN/ PoE port

Connect analog line to the FXO port(s)

Network connection

W04FXO has two kinds of work mode: route and bridge:

when it is set to route mode, it works as a small router and NAT function has enabled. In this situation,

WAN port is normally connected to uplink router/ switch, LAN port used to connect local computer or other

network device (such as Ethernet switches, Hubs etc)

Note: W04FXO 2020 is a wall-mounted Media Gateway.

W04FXO 2020 Quick Installation Guide

Page 3 of 3

when it is set to bridge mode, WAN and LAN port are the same. It just works as Ethernet switch. When it

set to bridge mode, you only need to configure WAN port IP address and DNS. If you set it to route mode,

default LAN port IP is displayed and it can be change by users

Provisioning

Follow our to provision the gateway.Provisioning of Wildix devices - Admin Guide

For remote/ unreachable media gateways behind NAT/Firewall, follow our .online Guide to remote provisioning

Configuration

Follow to correctly set up the trunk parameters of the FXO ISDN - FXO - GSM - SIP Trunk Settings Admin Guide

gateway.

Factory reset

Use the paper clip or the object of the similar shape to press the buttonReset

Keep the button pressed up to 15 seconds

When PWR and RUN LED indicators become steady green, the reset of the Gateway is complete

Wildix W04FXO Quick Installation Manual

Wildix W04FXO Quick Installation Manual

Wildix W04FXO Quick Installation Manual

Related papers

Other documents