months
0+
Instruction Manual
Travel Portacot
IMPORTANT
BEFORE ASSEMBLING THIS COT READ AND UNDERSTAND THE INSTRUCTIONS.
Do not use mattress other than the one supplied by the manufacturer.
Incorrect mattress can cause death.
Use only accessories as recommended by the manufacturer.
Ensure the top rails and base are fully locked.
Stop using this cot if any part of the cot is broken, torn or missing.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE.
- USE ONLY THE MATTRESS SUPPLIED BY THE MANUFACTURER, INCORRECT
MATTRESSES CAN CAUSE DEATH.
- Use only accessories as recommended by the supplier.
- Ensure the top rails and base are fully locked.
- Do not use this cot if any part of the cot is broken, torn or missing.
- Keep children away while assembling/disassembling the cot.
- Do not leave anything on the folding cot (such as toys) that provide a foothold.
- Do not use the folding cot near naked heat sources, bar heaters, open fires or
exposed flames.
- Do not place more than one child in the cot at the same time.
- Do not use this cot with a child who can climb out, weighs more than 15kg, or is
taller than 890mm.
- Keep the folding cot clear of trailing cables and hanging cords.
- Keep medication and small items that a child could choke on, away from the cot.
- Check that the assembly of the cot is correct and safe.
- Check that all locking devices are fully engaged.
- Folding cots with padded rims should not be used if the covering material has been
bitten through.
- There is potential for fingers or parts of the body to be injured when the product is
being folded or unfolded, and that due care should be exercised.
- Take care when unpacking and during assembly.
- Dispose of all packing materials carefully after assembly.
- Regularly check that all fittings remain tight. Tighten if required.
- Inspect the product before assembly and periodically during use. Never use this
product if there is any loose or missing fasteners, joints or broken parts.
- Be aware of the risk of open fires and other sources of strong heat, such as electric
bar fires, gas fires, etc. in the near vicinity of the cot.
- Any additional or replacement parts should only be obtained from the manufacturer
or distributer.
- Never substitute parts.
WARNING
WARNING:
RETAIN FOR FUTURE REFERENCE.
READ ALL INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY AND USE OF THIS COT.
ALWAYS FOLLOW THE INSTRUCTIONS.
THE CORRECT USE AND MAINTENANCE OF THIS PRODUCT IS ESSENTIAL.
2
A 1-Carry Bag
B 1-Cot
C 1-Mattress
PARTS LIST
A
C
B
3
THESE STEPS WILL ENSURE THAT THE COT IS
CORRECTLY OPENED AND READY TO USE.
01. TO OPEN THE COT
WARNING
A Unzip and remove the carry bag.
B Remove mattress by unfastening the
hook & loop straps, and take out the
portacot.
C Separate the legs of cot.
A
B
C
C
4
01. TO OPEN THE COT - CONTINUED
CAUTION : TAKE CARE
AS FINGER PINCHING CAN OCCUR IN
THE CORNER WHEN LOCKING THE
RAILS IN PLACE.
D Starting with long rails pull them up with both
hands quickly until they are locked into place.
E Repeat above step for the short rails.
NOTE: All the top rails should be locked in place.
If they are not, release them and try again. The
centre of the cot base must be in a raised position
to allow the rails to lock. Check for the secure
engagement of the rails by pushing down on them.
F Push the centre folding lever downwards until it
locks into place.
G Place the mattress into the cot with its padded
side facing up.
D
E
F
G
5
01. TO OPEN THE COT - CONTINUED
H Secure the mattress to the cot by fixing the hook &
loop fasteners under the mattress onto the cot base.
NOTE: Always secure the mattress before using
the cot.
02. TO FOLD THE COT
THESE STEPS MUST BE FOLLOWED IN THIS ORDER TO EASILY FOLD THE COT.
A Remove the mattress by unfastening the
hook & loop straps from the cot.
H
A
A
B Pull the centre folding lever upwards.
C Release each top rail by lifting the rail slightly
and pressing the buttons located on the centre
joint of rail.
IF THE TOP RAILS DO NOT FOLD, DO NOT
FORCE THEM - LIFT THE BASE HIGHER AND
PRESS THE BUTTONS TO FULLY RELEASE THEM.
B
C
6
02. TO FOLD THE COT - CONTINUED
D Ensure each rail is fully released, then pull the
centre folding lever up until it is fully folded.
E Place the cot in the mattress with padded side
facing inwards.
E
D
F Cover the folded cot with mattress by fastening
the hook & loop straps.
G Place the folded cot with mattress in carry
bag and zip it up.
F
G
G
7
- All assembly fittings are to be tightened properly. Inspect regularly and re-tighten
as necessary.
- Wipe clean with a damp cloth.
- Do not bleach.
- Do not iron.
- Do not dry clean .
- Do not use abrasive pads, bleach or strong household cleaners.
IMAGES/ DRAWINGS IN THE MANUAL ARE FOR VISUAL PURPOSES ONLY.
ACTUAL PRODUCT MAY VARY SLIGHTLY. THE MANUFACTURER RESERVES THE
RIGHT TO CHANGE ANY SPECIFICATION OR FEATURE WITHOUT PRIOR NOTICE.
Keycode : 42001409
MADE IN CHINA
©KMART AUSTRALIA LIMITED
ANKO AND KIDS&CO. ARE TRADEMARKS OF KMART AUSTRALIA LIMITED. THEY ARE USED IN
NEW ZEALAND BY KMART NZ HOLDINGS LIMITED TRADING AS KMART IN NEW ZEALAND.
KMART AUSTRALIA - 690 SPRINGVALE RD, MULGRAVE, VIC 3170 AUSTRALIA.
KMART NEW ZEALAND - REGIONAL OFFICE C/O KMART PAPATOETOE STORE HUNTERS PLAZA,
GREAT SOUTH RD, PAPATOETOE, AUCKLAND, NEW ZEALAND.
Care and maintenance
8
/
