IP3/IP4 Lightpipe Kit Instructions
The Lightpipe improves the IrDA communication reliability and
speed between your reader and the mobile device. This kit
includes the following contents:
• IP3/IP4 Reader Lightpipe with pre-applied adhesive
• IP3/IP4 Reader Lightpipe Instructions
Reader and Mobile Device Surface Preparation
1 Remove the existing gold reflector tape from your Reader. It is
recommended that you use rubbing alcohol to remove any
remaining reflector tape residue. However, do not use any sol-
vent remover that will harm the Reader plastic.
2 Remove the existing IR Reflector label on your mobile device
(if applicable). Ensure all label residue is removed from that
location.
Reader gold
reflector tape
Mobile device
reflector label