SignaMax Splice Trays for Rack-Mount Enclosures Installation guide

Brand
SignaMax
Model
Splice Trays for Rack-Mount Enclosures
Type
Installation guide
www.signamax.com
999 N.W. 159
th
Drive • Miami, FL 33169 • 800.446.2377 • 305.944.7710 • Fax: 305.949.4483
Copyright 2008 Signamax, Inc./AESP, Inc. All rights reserved • Signamax Connectivity Systems is a trademark of AESP, Inc. • Specifications subject to change.
FSTxxA 05282009
FST
-
12A & 24A
12- & 24-Fiber Aluminum Splice Tray for UFE Series Enclosures
1.0 General
The All-Purpose Optical Fiber Splice Tray FST-12A stores up to 12 fusion, 12 mechanical, or 4 mass
ribbon splices. The FST-24A stores up to 24 fusion, 24 mechanical, or 8 mass ribbon splices. Entrances
of buffer tubes are located on both ends from the middle providing, inline or butt configuration, while
maintaining minimum fiber bend radii.
2.0 Prepare Organizer and Fiber
Select right- or left-angle splice holder and attach to
tray. Place in proper location and proper direction to
accommodate ease of splice positioning. (figure 1)
2.2 Attach any mounting material to the bottom of the tray,
as specified by splice case being used.
2.3 Trim buffer tube to expose 36”-48” of individual 250µm
fiber and clean per company practice.
3.0 Install Buffer Tubers into Tray
3.1 Install buffer tubes into Buffer Tube attachment clamps
or tie wrap slots. The buffer tube should stop within ¼
of the end of clamp or tie wrap.
Ribbon Fusion (Left Angle)
Fusion w/ Sleeve (Left Angle)
Fusion w/ Sleeve (Right Angle)
Ribbon Fusion (Right Angle)
Figure 1
3.2 Lay ay least 1”-loop of fiber in a tray of each fiber in the buffer tube.
3.3 Remove fibers from tray, leaving buffer tube in place, and splice per company practice.
4.0 Fiber Storage and Routing
4.1 Route fiber in tray and through splice holder. Fiber should be routed by placing fiber under retaining
plates.
5.0 Installation of Additional Trays or Cover
5.1 Snap cover into place and attach Velcro dots to cover. Attach Velcro dots to bottom of top tray and
attach to bottom tray cover.
Premise Connectivity Systems
  • Page 1 1

SignaMax Splice Trays for Rack-Mount Enclosures Installation guide

Brand
SignaMax
Model
Splice Trays for Rack-Mount Enclosures
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents