Page is loading ...
Dr. RDM I DMX RDM
Tester
controller
User manual
Musikhaus Thomann
Thomann GmbH
Hans-Thomann-Straße 1
96138 Burgebrach
Germany
Telephone: +49 (0) 9546 9223-0
E-mail: [email protected]
Internet: www.thomann.de
06.03.2020, ID: 421279 (V2)
Table of contents
1 General information................................................................................................................................. 6
1.1 Further information........................................................................................................................... 7
1.2 Notational conventions.................................................................................................................... 8
1.3 Symbols and signal words............................................................................................................ 10
2 Safety instructions.................................................................................................................................. 11
3 Features....................................................................................................................................................... 13
4 Installation and starting up................................................................................................................ 14
5 Connections and controls................................................................................................................... 16
6 Operating.................................................................................................................................................... 19
6.1 Main menu.......................................................................................................................................... 20
6.2 DMX 512 test...................................................................................................................................... 21
6.3 RDM test.............................................................................................................................................. 35
6.4 MIDI test.............................................................................................................................................. 64
6.5 Cable test............................................................................................................................................ 66
6.6 System settings................................................................................................................................. 69
Table of contents
Dr. RDM I DMX RDM Tester
3
controller
7 Technical specications....................................................................................................................... 74
8 Plug and connection assignment.................................................................................................... 76
9 Protecting the environment.............................................................................................................. 77
Table of contents
4
Dr. RDM I DMX RDM Tester
controller
Dr. RDM I DMX RDM Tester
5
controller
1 General information
This user manual contains important information on the safe operation of the device. Read and
follow all safety notes and all instructions. Save this manual for future reference. Make sure
that it is available to all persons using this device. If you sell the device to another user, be sure
that they also receive this manual.
Our products and user manuals are subject to a process of continuous development. We there‐
fore reserve the right to make changes without notice. Please refer to the latest version of the
user manual which is ready for download under www.thomann.de.
General information
6
Dr. RDM I DMX RDM Tester
controller
1.1 Further information
On our website (www.thomann.de) you will nd lots of further information and details on the
following points:
Download This manual is also available as PDF le for you to download.
Keyword search
Use the search function in the electronic version to nd the topics of
interest for you quickly.
Online guides
Our online guides provide detailed information on technical basics
and terms.
Personal consultation For personal consultation please contact our technical hotline.
Service
If you have any problems with the device the customer service will
gladly assist you.
General information
Dr. RDM I DMX RDM Tester
7
controller
1.2 Notational conventions
This manual uses the following notational conventions:
The letterings for connectors and controls are marked by square brackets and italics.
Examples: [VOLUME] control, [Mono] button.
Texts and values displayed on the device are marked by quotation marks and italics.
Examples: ‘24ch’ , ‘OFF’ .
Letterings
Displays
General information
8
Dr. RDM I DMX RDM Tester
controller
The individual steps of an instruction are numbered consecutively. The result of a step is
indented and highlighted by an arrow.
Example:
1. Switch on the device.
2. Press [Auto].
ð
Automatic operation is started.
3. Switch o the device.
References to other locations in this manual are identied by an arrow and the specied page
number. In the electronic version of the manual, you can click the cross-reference to jump to
the specied location.
Example: See
Ä
‘Cross-references’ on page 9.
Instructions
Cross-references
General information
Dr. RDM I DMX RDM Tester
9
controller
1.3 Symbols and signal words
In this section you will nd an overview of the meaning of symbols and signal words that are
used in this manual.
Signal word Meaning
DANGER! This combination of symbol and signal word indicates an
immediate dangerous situation that will result in death or
serious injury if it is not avoided.
NOTICE! This combination of symbol and signal word indicates a pos‐
sible dangerous situation that can result in material and
environmental damage if it is not avoided.
Warning signs Type of danger
Warning – danger zone.
General information
10
Dr. RDM I DMX RDM Tester
controller
2 Safety instructions
This device is for testing devices that are controlled via DMX, RDM or MIDI or output these sig‐
nals. Use the device only as described in this user manual. Any other use or use under other
operating conditions is considered to be improper and may result in personal injury or prop‐
erty damage. No liability will be assumed for damages resulting from improper use.
This device may be used only by persons with sucient physical, sensorial, and intellectual
abilities and having corresponding knowledge and experience. Other persons may use this
device only if they are supervised or instructed by a person who is responsible for their safety.
DANGER!
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are not
within reach of babies and young children. Choking hazard!
Ensure that children do not detach any small parts (e.g. knobs or the like) from
the unit. They could swallow the pieces and choke!
Never let children unattended use electrical devices.
Intended use
Safety
Safety instructions
Dr. RDM I DMX RDM Tester
11
controller
NOTICE!
External power supply
The device is powered by an external power supply. Before connecting the
external power supply, ensure that the input voltage (AC outlet) matches the
voltage rating of the device and that the AC outlet is protected by a residual cur‐
rent circuit breaker. Failure to do so could result in damage to the device and pos‐
sibly the user.
Unplug the external power supply before electrical storms occur and when the
device is unused for long periods of time to reduce the risk of electric shock or
re.
NOTICE!
Operating conditions
This device has been designed for indoor use only. To prevent damage, never
expose the device to any liquid or moisture. Avoid direct sunlight, heavy dirt, and
strong vibrations.
Safety instructions
12
Dr. RDM I DMX RDM Tester
controller
3 Features
n Universal test device for DMX, RDM and MIDI networks
n 5-pin DMX in and output
n MIDI input
n Plug-in power supply and adapter for 3-pin DMX plug included
n Operating via buttons and display on the unit
Features
Dr. RDM I DMX RDM Tester
13
controller
4 Installation and starting up
Unpack and check carefully there is no transportation damage before using the unit. Keep the
equipment packaging. To fully protect the product against vibration, dust and moisture during
transportation or storage use the original packaging or your own packaging material suitable
for transport or storage, respectively.
Create all connections while the device is o. Use the shortest possible high-quality cables for
all connections. Take care when running the cables to prevent tripping hazards.
The included lanyard can be threaded through the bottom of the device.
Only rechargeable NiMH batteries may be used.
The battery compartment is located on the back of the device.
Inserting batteries
Installation and starting up
14
Dr. RDM I DMX RDM Tester
controller
The batteries are not included in the scope of delivery.
1. Loosen the screw of the battery compartment cover using a cross-head screwdriver.
Remove the cover.
2. Insert the batteries (4 × NiMH, AAA, rechargeable) into the battery compartment. Pay
attention to the correct location of the poles.
3. Replace the battery compartment cover. Tighten the cover.
Use the included power adapter for charging the inserted batteries.
Connect the supplied mains adapter to the power supply input of the device and then
plug the adapter into an AC outlet.
ð
The batteries are being charged. The LED [Normal] lights when the batteries are fully
charged.
Charging the batteries
Installation and starting up
Dr. RDM I DMX RDM Tester
15
controller
5 Connections and controls
Connections and controls
16
Dr. RDM I DMX RDM Tester
controller
1 Jog Wheel for control and menu selection
2 Display
The display is turned o after an adjustable period of time without keystroke. Press the jog wheel to reactivate the
display.
3 [DMX/RDM OUT]
5-pin DMX / RDM output
4 [DMX/RDM IN]
5-pin DMX / RDM input
5 [MIDI IN]
MIDI input
6 [Power Switch]
Main switch. Turns the device on and o.
7 [PWR]
The LED indicates that the device is switched on.
Connections and controls
Dr. RDM I DMX RDM Tester
17
controller
8 [Program Update]
Micro SD slot
9 [Under Voltage]
This LED lights up when the supply voltage is too low.
10 [Normal]
The LED indicates that the supply voltage is within the permissible range.
11 [DC INPUT]
Connector for the supplied power supply adapter.
Connections and controls
18
Dr. RDM I DMX RDM Tester
controller
6 Operating
The device can be powered by batteries or with the included AC adapter.
Use with batterie: Insert the batteries into the device.
Ä
‘Inserting batteries’ on page 14
Use with power adapter: Connect the supplied mains adapter to the power supply input of the
device and then plug the adapter into an AC outlet.
Operating
Dr. RDM I DMX RDM Tester
19
controller
6.1 Main menu
1. Turn the jog wheel to highlight a menu item.
2. Press the jog wheel to select the highlighted menu item.
3. Press the jog wheel again to open the associated submenu.
4. The display shows the available elements of the submenu.
5. Select the menu item ‘EXIT’ and press the jog wheel to return to the main menu.
Selection in main menu
Operating
20
Dr. RDM I DMX RDM Tester
controller
/