SNK1010
TAP HOLE REMOVAL
Remove sink from packaging and support under the edges.
Check the indicator to make sure you have selected correct handed hole.
Using a centre punch, chisel or sturdy instrument carefully hit the sink on the marker
indicated; this must be from the top glazed surface.
When the tool has made a small hole, carefully chip away until the hole is the correct
size.
When hole is finished the tap when fitted will cover any small irregularities.
Stephen Harrington
Appliance Technical
12.11.10
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Champion Power Equipment 50075 User manual
-
Miele TAP1130 Owner's manual
-
LAMONA Arroscia 3 in 1 Polished Chrome Right Angled Hot Water Tap Installation guide
-
AGA Traditional 4 in 1 Tap Owner's manual
-
-
Zenith HydroTap G4 Celsius Series Installation Instructions Manual
-
SERVIS M9913 Owner's Handbook Manual
