4
GENERAL SAFETY (CONT.)
Before first use
• Unpack the fan and accessories and ensure all parts of the product are
undamaged and in good working order.
• Plastic wrapping can be a suocation hazard for babies and young
children, so ensure all packaging materials are out of their reach and
disposed of safely.
• Ensure the fan is not exposed to direct sunlight or placed near a
heater or other heat source.
ASSEMBLY
1: Place the fan stand on the base and snap together.
2: Loosen guard lock nut from the motor housing.
3: Position rear guard firmly to motor housing and then fasten by turning
guard lock nut clockwise tightly.
4: Push the blade along motor shaft. Fasten it firmly with spinner by
turning counter clockwise.
5: Hang the front guard to rear guard with the position fixer provided at
the rim of guard and then fix together with screw and nut provided.
Before installing this product, make sure your outlet voltage corresponds to
the voltage stated on the product rating label.
• Do not use a damaged power cord, plug or loose outlet.
Doing so may cause an electric shock.
• Do not plug several devices into the same outlet. Doing so may cause the out
let to overheat and start a fire. Make sure the outlet is readily accessible
during operation of the equipment.
• Do not bend, twist or kink the power cord excessively.
• Do not allow anything to rest on or roll over the power cord.
Doing so may cause a fire or an electric shock.
• Do not run the power cord near heat-producing appliances such as radiators,
stoves or irons. The excessive heat could melt the insulation and expose live
wires, resulting in fire or electric shock.
• Do not expose this product to water. The electrical insulation could be dam
aged and cause electrocution. Do not touch the unit when barefoot or parts of
your body are wet or damp. If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.