Rev-A-Shelf SBDT-2730-A-1 Installation guide

Type
Installation guide
I-SBDT-0412
Drip Tray
Installation Instructions
TOOLS REQUIRED:
ESTIMATED ASSEMBLY
TIME:
25 MIN
This product is designed for both new and existing cabinet installation.
If no plumbing is present or your plumbing comes in from the rear of the cabinet,
proceed to the ‘New Construction” section. If your plumbing already exists and comes up
12400 Earl Jones Way, Louisville, KY 40299
1-800-626-1126 •rev-a-shelf.com
Sink/Vanity Base applications
New Construction (No plumbing present)
1) Measure the inside width and depth
of your base cabinet.
Note: When measuring the depth, make
sure to include the face frame thickness.
2) To trim your Drip Tray, only a utility
knife and straight edge is required. Begin by
scoring the cut line several times and simply
break on the score line. You can also do this
using a powered saw, but is not necessary.
3) Since the Drip Tray ts over the face frame and in
most cases a center mullion, you will need to trim Drip
Tray to t ush to the front. A utility knife may be used
to make the cuts, but a power tool (jig saw, scroll saw,
etc) might give you a little more control.
4) Once tray is tted inside
cabinet, use silicon adhesive
around the entire perimeter
and any holes you made for
plumbing. Take care to seal
all the cuts to ensure a water
tight seal.
Sink/Vanity Base Applications
Existing Construction (oor plumbing present)
1) Measure the inside width and
depth of your base cabinet.
Note: When measuring the depth,
make sure to include the face frame
thickness.
2) To trim your Drip Tray, only a utility
knife and straight edge is required. Begin
by scoring the cut line several times and
simply break on the score line. You can
also do this using a powered saw, but is
not necessary.
4) Everyones plumbing congurations are dierent
so you will need to measure each of the location of each
pipe that comes up through cabinet base. You will then
need to transfer these exact locations to your drip tray
and cut out.
3) Since the Drip Tray ts over the face frame and
in most cases a center mullion, you will need to trim
Drip Tray to t ush to the front. A utility knife may
be used to make the cuts, but a power tool (jig saw,
scroll saw, etc) might give you a little more control.
5) Use silicon adhesive around
the entire perimeter and any
holes you made for plumbing.
Take care to seal all the cuts to
ensure a water tight seal.
NOTE: If your base cabinet is constructed with recessed bottom doors and a
center mullion, it may be impossible to install as one piece.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Rev-A-Shelf SBDT-2730-A-1 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI