Futaba PS-10BR 5.2 User manual

󾛽

WARNING

￸

If using a power switch, always connect it between

battery and PS-10.

s)FCONNECTINGTHESWITCHBETWEEN03ANDRECEIVERSSINCE

VERYSMALLCURRENTmOWSINTO03EVENIFITISTURNEDOFFIT

WILLCAUSEOVERDISCHARGINGOFABATTERY

￺

Do not connect PS-10 and other regulators or

batteries simultaneously.

s-ULTIPLECONNECTIONMAYCAUSESMOKElREANDDAMAGE

￺

Never connect the battery in reverse.

s2EVERSECONNECTIONMAYCAUSESMOKElREANDDAMAGE

￸

Always ﬁx the PS-10 securely to the fuselage of the

airplane or helicopter.

s)FTHECONNECTORWORKSLOOSEDUETOVIBRATIONANDSHOCK

OPERATIONWILLBE IMPOSSIBLEAND THERE ISTHE DANGER OFA

CRASH

￺

Do not wrap the PS-10 in sponge, etc.

s3UCH WRAPPING WILL CAUSE A LOSS OF COOLING EFFECT AND THE

SPECIlEDPERFORMANCESWILLNOTBEOBTAINED

￺

Do not continue to operate when the servo is locked

or the rated output of the PS-10 is exceeded.

s)FA

PROTECTIONCIRCUIT OPERATESANDSTOPSTHESUPPLY OF POWER

TOTHERECEIVER AND SERVOS

OPERATIONWILL BEIMPOSSIBLEAND

THEREISTHEDANGEROFACRASH

7HENTHEPROTECTIONCIRCUITHASOPERATEDREMOVETHECAUSEOF

THEOVERLOADANDWAITABOUTHOURBEFORERESUMINGUSE

󾛽

CAUTION

￺

Do not bend the ﬂange with unreasonable force.

s4HEmANGEMAYBEBROKEN

Regulator for Receiver

Thank you for purchasing a

PS-10

regulator for receiver.

When you want to use an ordinary 4.8V rating receiver and servos with a high-

voltage (HV) rating battery (LiFe or LiPo), you can step down the receiver and

servo power to 5.2V by connecting the

PS-10

between the battery and the receiver.

[PS-10 BR5.2 Ratings]

2EGULATORFOR2ECEIVER

s-AIN APPLICATION 0OWERSUPPLY FOR6

RATINGRECEIVERANDSERVOS

s)NPUTVOLTAGERANGE6^6

s/UTPUTVOLTAGE6

s2ATEDOUTPUTCURRENT!-AX!SEC

s/PERATINGTEMPERATURERANGE^#

s3TORAGETEMPERATURERANGE^#

s$IMENSIONSXXMM

s7EIGHTG

Usage Precautions

Connection

s&OR'(ZSYSTEMONLY$ONOTUSE03FORANYSYSTEMSOTHERTHAN'(ZSYSTEM

s!LWAYSUSE03BETWEENABATTERYANDARECEIVER)TCANNOTBEUSEDBETWEENARECEIVERANDASERVO

s5SE THE 03 WITHIN lVE SERVOSAS THE STANDARD (OWEVERTHE MAXIMUM NUMBER OF SERVOS WHICH CAN BE

driven by it differs depending on the servo and conditions to be used. Always use the PS-10 within the limits

of the PS-10 ratings.

Switch

Connect to

receiver

,I&E,I0O

battery

6^6

"ATTERYRATING

/UTPUT6)NPUT

-.

&UTABA#ORP WILLNOTBERESPONSIBLEFOR DAMAGES ETC CAUSEDBY

COMBINATIONWITHOTHERTHAN&UTABA#ORPPRODUCTS

FUTABA CORPORATION oak kandakajicho 8F 3-4 Kandakajicho, Chiyoda-ku, Tokyo 101-0045, Japan

TEL: +81-3-4316-4820, FAX: +81-3-4316-4823

Before using your new PS-10, please read this manual thoroughly and use it

properly and safely. After reading this manual, store it in a safe place.

7HENINSTALLINGTHE03TOTHEFUSELAGEUSETHE

MOUNTING mANGE AND THE SPACER IF NECESSARY 5SE THE

SPACERAFTERCUTTINGOUTITFROM03USINGNIPPERSETC

Mounting ﬂange

Spacer

PS-10

Cooling effect:

The aluminum case is used for a face plate so that it can radiate the

internal heat efﬁciently. Mount PS-10 so that the aluminum case is exposed.

If PS-10 is mounted to the fuselage in the state where the aluminum case

side is turned down and wrapped in sponge etc., it will cause a loss of

cooling effect and the speciﬁed performances will not be obtained.

*It uses cutting

Futaba PS-10BR 5.2 User manual

Related papers

Other documents