Triton Systems RT2000 Series Owner's manual

Brand
Triton Systems
Model
RT2000 Series
Type
Owner's manual

This manual is also suitable for

TDN 07103-00149B
TDM EXTENSION LATCH UPGRADE
STEP 1
Lay dispenser on the cassette(s) end. On the under-
side of the bill extension, remove the two (2) torx screws
that secure the pull-handle cable. Discard the screws/
handle.
STEP 2
Mount the extension latch as shown below and secure
with four (4) torx screws provided. Two (2) screws
are secured where the handle cable was located (white
and two (2) screws are secured in the holes located in
figure above (yellow).
OPENING LOWER ACCESS DOOR
Grasp top of latch and “flip” down. This now becomes
the “Handle”. Grasp latch and pull lower access door
down. This allows for retrieval of any jammed notes, if
applicable. Push lower door back up and secure with
latch.
The following illustrations show the field installation of the extension latch for TDMdispensers with the “Billfish”
extension. This upgrade is for Model RT2000 units. To perform this upgrade in fielded units requires removal of
the dispenser from the cabinet. Tool required for upgrade is a T-6 Torx driver (included in kit).
STEP 3
Rotate the slotted front up and “snap” in place. The fig-
ure below shows latch installed.
TOOLS REQUIRED:#
6-TTORX DRIVER
(INCLUDED)
edargpUhctaLnoisnetxEMDT
( )76100-00260N/P
rebmuNtraP noitpircseD
68700-51030yssAnoisnetxEMDT,hctaL
47100-45020)4-ytQ(,gnippat-fleS,6-T,wercS
51000-51120revirdxroT6-T#
*
33001-00250
DCedargpUerawtfoSTR/TF/LR
* 94100-30170tnemucodotrefeRnoisnetxEMDT(edargpUhctaL
)
DCno
T-6 Torx driver
  • Page 1 1

Triton Systems RT2000 Series Owner's manual

Brand
Triton Systems
Model
RT2000 Series
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents