Inventory (Figure 2)
A.
B.
C.
D.
Hardware
MODEL G0712
STAND INSTRUCTIONS
(STAND FITS MODEL G0711
PLANISHING HAMMER)
Figure 1.
Damage to your eyes, feet, and ears could
result from using this item without proper
protective gear, such as safety glasses,
steel-toe boots, and hearing protection.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
Figure 2. Inventory.
The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Assembly
To assemble the planishing hammer stand:
1.
Figure 3
Steps 1 & 2
Step 3
Step 4
Figure 3. Connecting rear upright to table
assembly.
Steps 1 & 2
Step 3
Step 4
Figure 5. Securing lower support to foot
assembly.
Steps 1 & 2
Step 3
Step 4
Figure 6. Securing lower support to rear upright.
Steps 1 & 2
Step 3
Step 4
Figure 4. Attaching foot assembly.
2.
Figure 4
3.
Figures 5–6
4. Steps
13.
The Model G0712 must be mounted securely
to the floor to prevent it from tipping and fall-
ing during use. Failure to mount the stand to
the floor could cause crushing, impact, or
cutting injuries if the stand, planishing ham-
mer, and/or workpiece fall during use
NOTICE
Anchor studs are stronger and more per-
manent alternatives to lag shield anchors;
however, they will stick out of the floor,
which may cause a tripping hazard if you
decide to move your machine.
Figure9
7.
5.
Figure 7
Tip: Tilt the stand as needed when adding
sand to fill it above the ports and get the
maximum mass.
Tip: Fill the stand with a heavier material,
such as steel grit blast media, for increased
mass and vibration damping.
6.
Figure 8.
8.
Figure 9
If you need help with your new item, call our Tech
Support at: (570) 546-9663.
Steps 1 & 2
Step 3
Step 4
Figure 7. Stand plugs.
Steps 1 & 2
Step 3
Step 4
Figure 8. Mounting planishing hammer to stand.
Parts
1
2
3
4
5
6
7
8
9
10
11
12
13
13
14
11
7
9
10
10
9
10
10
5
9
10
4
10
REF PART # DESCRIPTION REF PART # DESCRIPTION
1 P0712001 FOOT ASSEMBLY 8 P0712008 LOWER SUPPORT
2 P0712002 TABLE ASSEMBLY 9 PLW04M LOCK WASHER 8MM
3 P0712003 REAR UPRIGHT 10 PW01M FLAT WASHER 8MM
4 PB166M HEX BOLT M8-1.25 X 50 11 P0712011 STAND PLUG
5 PB184M HEX BOLT M8-1.25 X 75 12 PB32M HEX BOLT M10-1.5 X 25
6 PB09M HEX BOLT M8-1.25 X 20 13 PW04M FLAT WASHER 10MM
7 PN03M HEX NUT M8-1.25 14 PLN05M LOCK NUT M10-1.5
/
