2. Lumination
  3. LIS Series LED Endcap Accessory

Lumination LIS Series LED Endcap Accessory Installation guide

  • Hello! I'm your chat assistant, and I've reviewed the Installation Guide for the IS Series Endcap Cover Accessory. This document outlines the procedure for attaching both the female and male end caps to the Lumination LED luminaire, highlighting the differences in their installation methods. I'm here to answer any questions you might have about this accessory and its installation process.
  • Are the end caps identical?
    How is end cap A attached?
    How is end cap B attached?
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 1
(Rev 05/17/23)
IND190 - Lumination IS Series LED Endcap Accessory - Installation Guide_R01
Installation Guide
IND190 | 052715
Lumination® LED Luminaire
Endcap Cover Accessory
IS Series
ABMale end cap
Female end cap
The end caps are not identical. The clipping xture is a female at one side (A) and a male at the other side (B).
1
A
B
CLICK!
CLICK!
Push both end caps onto xture. End cap A will snap on. End cap B will require two screws to secure.
NOTE: Follow similar procedure for continuous run installations.
2
/