5.0/0814/TG
PORTABLE BASSINET ‘N
CRADLE WITH TOYBOX BASE
MODEL NUMBERS*:
00620 - White Batiste Long Skirt
00630 - White Batiste Half Skirt
00631 - Sage Gingham
00632 - Sage Wafe Pleated
00633 - Ecru Wafe Pleated
00634 - Pink Wafe Rufed
00635 - Blue Wafe Rufed
00636 - Sage Wafe Rufed
Assembly and Use Instructions. Read all instructions
before use. This manual is part of the product and
must be saved for future reference.
If you need product parts,
see below or Page 2!
FOR REPLACEMENT PARTS:
Go to our web site: http://www.badgerbasket.com/parts
Or scan QR code at right with your smartphone
VERSION CODE*:
5.0/0814/TG
* These numbers are needed if
replacement parts are requested
5.0/0814/TG
BEFORE YOU BEGIN ASSEMBLY:
Check all parts and hardware. If anything is missing
or not satisfactory, please DO NOT call the store
or return the product to them.
Please go online to
http://www.badgerbasket.com/parts
for assistance. Most problems are resolved promptly
without you needing to leave home. When contacting us,
please have this instruction manual, your product model
number, and your product version code ready.
Your Product Model Number: See Cover Page
Your Product Version Code is: 5.0/0814/TG
Additional tted sheets are available and sold separately.
White Fitted Sheets - Model #00020 - UPC Code 0-46605-10020-2
CARE INSTRUCTIONS:
Wipe bassinet and vinyl/foam pad clean with a damp cloth and mild detergent as
needed. Bedding can be machine washed on cold, gentle cycle, and air dried or
tumble dry on low or no heat. Iron on lowest setting for polyester/cotton.
Secure any hook-and-loop tape tabs together before washing so they do not
catch on the bedding or ribbons.
Badger Basket Company, PO Box 227, Edgar, WI 54426-0227 USA • Web: www.badgerbasket.com
Toll-Free (Mon-Thurs 7:30 AM-3:30 PM CST): 1-800-236-1310
Phone: 715-352-2311 • Fax: 715-352-3163
5.0/0814/TG
• SUFFOCATION HAZARD - Infants can suffocate:
» in gaps between an extra pad and the side of the bassinet,
» on soft bedding.
NEVER add a mattress, pillow, comforter, or padding. Use ONLY the pad and/or bedding provided by the
manufacturer. If a sheet is used with the pad, use only the one provided with the bassinet or one that is from Badger
Basket Company or one that is specically designed to t the dimension of the the mattress provided. ALWAYS use
a sheet that ts securely on the mattress and wraps around the mattress corners. Only a tted sheet, mattress pad
and/or waterproof pad should be used under the baby.
• Use ONLY the bedding designed for this bassinet from Badger Basket Company. Secure the liner/cover as
instructed in this manual and check regularly to ensure it remains tied.
• READ ALL INSTRUCTIONS before use of this product.
• Keep instructions for future use.
• Use only the parts and hardware provided by Badger Basket.
• Hardware may include small parts. Choking Hazard! Keep unassembled parts out of the reach of small children.
• Do not use the product if it is damaged, broken, torn, or missing parts.
• TO REDUCE THE RISK OF SIDS: pediatricians recommend that healthy infants be placed on their backs to
sleep, unless otherwise advised by your physician.
• DO NOT move or carry the bassinet with your baby inside of it.
• DO NOT allow other children or pets to climb or lean into or onto the bassinet when your infant is inside.
• DO NOT attach or place toys with strings in or around the bassinet. Strings can cause strangulation or choking.
• Keep bassinet away from stoves, heaters, camp res/ames, replaces, stairs, open windows, running or standing
water, and any other hazard which could cause injury to your baby.
• Be sure that your baby’s sleep space is a safe distance from windows and any curtains, shades, blinds, or window
coverings or decorations that may pose a danger from dangling or loose fabrics and cords.
• NEVER use plastic bags inside the basket such as to cover the mattress.
• Bassinet should always be placed on a rm, at surface. It should never be placed near stairs or on tables or elevated
surfaces.
• No product is a replacement for adult supervision.
• DO NOT allow anyone to climb, stand on, or play on or inside of this product. It is not a step stool or ladder.
• BE AWARE of what items are in the area around the bassinet that your child can reach, grab, or pull that could be
a choking, electrical, strangulation, injury, or other type of hazard.
• DO NOT make adjustments to the bassinet while child is inside.
• NEVER place the bassinet near re or open ame nor other sources of intense heat.
• NEVER place infants to sleep on pillows, sofa cushions, adult beds, waterbeds, beanbags, or any other surface not
specically designed for infant sleep.
• Remove pillows, sheepskins, pillow-like stuffed toys and products not intended as infant bedding from the bassinet
when your infant is sleeping.
• Do not overdress your baby. Cover the baby with a thin covering, such as a crib blanket, receiving blanket or other
blanket specically designed for infants, which covers only up to the baby’s chest, and tuck the covering around the
mattress. For newborns, consider swaddling. Consider using a wearable blanket.
• Check periodically for loose threads or stitching which could cause gagging or choking.
FALL HAZARD: To help prevent falls, please note this
bassinet is a safe place for your newborn to sleep until Baby is
20 lbs. (9.09 kg), OR when Baby can push up, roll over,
or crawl - whichever limit comes rst.
WARNING - FAILURE TO FOLLOW
THESE WARNINGS AND THE
INSTRUCTIONS COULD RESULT
IN SERIOUS INJURY OR DEATH:
TOOL REQUIRED(NOT INCLUDED)
Dx1
Bx2
Ex2
Cx2
Ax2
Fx4
5x35mm
Gx4
6x45mm
Hx8 Ix1
Jx2
Kx1
L1x1
Mx1
Nx1 Ox1
Px1
END PANELS BOTTOM RAIL TOY BOX SIDE PANELS
TOY BOX BOTTOM PANEL
DOWELS FOR MESH BASKET
WHEEL
WHEEL BOLT AND KNOB
LONG BOLT
TOP RAIL WITH SNAP
FABRIC CANOPY
FABRIC FITTED SHEET VINYL/FOAM PAD FABRIC LINER/SKIRT
BASSINET BODY
L2x1
CANOPY HOOP
WITH HINGES
CANOPY SUPPORT
HOOP
MESH BASKET
6x45mm
Hx4
①
②
A
J
J
B
B
H
H
H
H
H
A
H
H
H
6x45mm
Hx4
NOTE: THE GROOVES ON PARTS (B) FACE UP. THE GROOVES ON PARTS (J) FACE
DOWN AND THE SNAPS FACE OUT.
③
④
5x35mm
Fx4
NOTE: ATTACH ALL FOUR WHEELS IN THIS STEP(ONE IS NOT SHOWN IN THE DIAGRAM ABOVE).·
TIP:ATTACHING THE MESH BASKET MAY BE EASIER IF YOU TURN THE BASSINET STAND UPSIDE DOWN.
SLIDE THE DOWELS THROUGH THE POCKETS ON THE EDGES OF THE MESH BASKET.·
THEN INSERT ONE OF THE DOWELS INTO THE SLOTS CUT ON THE INSIDE FACES OF THE END PANELS.·
STRETCH THE MESH BASKET AROUND THE BOTTOM RAILS TO THE OTHER SIDE;AND INSERT THE SECOND DOWEL INTO THE SLOTS.·
ADJUST THE MESH BASKET TO REMOVE WRINKLES.·
NOTE: TO USE THE BASSINET AS A ROCKING CRADLE, LOOSEN THE CASTER KNOBS, ROTATE THE CASTERS INTO THE UP POSITION, ·
AND RETIGHTEN THE KNOBS SECURELY.
NOTE: FOLLOW STEPS 4, 5,AND 6 TO ASSEMBLE THE BASE AS A TOYBOX.
IF YOU ARE NOT CONVERTING THE BASE TO A TOYBOX AT THIS TIME, SKIP THESE STEPS AND GO ·
TO STEP 7.
· IF YOU ARE FOLLOWING THESE STEPS AFTER HAVING USED THE BASE WITH THE BASSINET AND
THE MESH BASKET, YOU WILL NEED TO FIRST UNSNAP AND REMOVE THE TOP/BASSINET BODY .
· NEXT, REMOVE THE TWO DOWELS AND THE MESH BASKET.
· THEN REMOVE ONE PANEL(PART A).
· YOU MAY REMOVE THE WHEELS, WHEEL KNOBS,AND WHEEL BOLTS IF DESIRED.
· RETAIN ALL UNUSED PARTS IN A SAFE PLACE FOR FUTURE USE. IF YOU LOSE ANY PARTS AND NEED TO
PURCHASE REPLACEMENTS, YOU WILL NEED THE MODEL NUMBER, VERSION CODE, AND DATE OF
MANUFACTURE OF THE ITEM. SO PLEASE RETAIN THIS ASSEMBLY MANUAL AND DO NOT REMOVE ANY
LABELING FROM THE PRODUCT.
G
F
G
F
G
F
E
E
I
C
C
⑤
⑥
H
A
H
H
H
6x45mm
Hx4
D
P
⑦
⑧
ROTATE THE SIDE FRAME SUPPORT BARS AROUND
BENEATH THE BASSINET BODY (PART P)
LOCATE THE FRAME SUPPORT FLANGES ON THE BOTTOM OF THE
BASSINET BODY (PART P).
SECURE THE FRAME SUPPORT BARS BENEATH THE FLANGES.
BE SURE THE BARS ARE SNAPPED IN SECURELY.
IT IS HELPFUL TO PUSH ON THE BOTTOM OF THE BASSINET BODY
FROM INSIDE TO MAKE IT EASIER FOR THE BARS SNAP IN.
THE FABRIC ON THE BASSINET BODY SHOULD BE TIGHT AND
TAUT WHEN THE FRAME SUPPORT BARS ARE PROPERLY IN PLACE.
K
L1
⑨
⑩
THREAD THE CANOPY HOOP WITH HINGES (PART L1)
THROUGH THE LARGE POCKET ON THE FABRIC CANOPY
(PART K).
THREAD THE CANOPY SUPPORT HOOP (PART L2) THROUGH
THE SMALL POCKET ON THE FABRIC CANOPY AND SECURE
THE GRIP TAPE AT BOTH SIDES OF THE POCKET TO KEEP IT
IN PLACE.
L2
SNAP THE CANOPY HOOP WITH HINGES
(PART L1) INTO THE CANOPY POCKETS ON
THE BASSINET BODY (PART P).
PUSH DOWN TO SNAP SECURELY IN PLACE.
ADJUST CANOPY POSITION AS NEEDED. IT
CAN BE FULLY OPEN, FOLDED FLAT, OR MANY
POSITIONS IN BETWEEN.
11
SECURE THE BASSINET BODY TO THE ASSEMBLED BASE.
FIT THE SLOTS ON THE BOTTOM OF BASSINET BODY
(PART P) OVER THE POSTS ON THE BASE.
THEN SNAP THE STRAPS ON THE BASSINET BODY TO
THE SNAPS ON THE TOP RAILS (PART J).
THE BASSINET BODY CAN BE UNSNAPPED AT ANY
TIME TO USE AS A PORTABLE BED.
NEVER USE THE BED IN THE CAR! IT IS NOT A CAR SEAT!
M
N
O
NOTE: DRESS THE LINER/SKIRT ONTO THE ASSEMBLED BODY/FRAME UNIT WITH THE CORRECT SIDE FACING
OUT SO THAT YOU CAN SECURE THE GRIP TABS AROUND THE CANOPY POSTS.
PUT THE FITTED SHEET OVER THE PAD AND PLACE THEM INSIDE THE BASSINET.
FOR MODEL 00620: ALSO SECURE THE ADDITIONAL TABS KEEP THE EDGES OF THE SKIRT TOGETHER.
1
2
/
