DA-JB2000 INSTALLATION MANUAL
This manual is intended for users of the DA-JB2000 wall mounting
bracket. It includes instructions for mounting the DA-JB2000 wall
mounting bracket to a wall.
• This bracket is intended to be used with DC-T series
model of camera. Do not use it with other models of
cameras.
• This installation should be performed by a qualied
service personnel in conformance to all local codes.
• You may need to reinforce the wall. If the wall is not
strong enough to support the camera, the camera may
fall.
• Do not use this product for other purposes.
Mounting
Mount the bracket to the wall as follows:
1
Insert cables from external
devices, network and power
adapter to the sponge and
bracket.
2
Mount the sponge to the wall and
then bracket to the sponge by
using the anchors and screws.
Screw #8X25, 4EA
Wall
Bracket
Rubber
Sponge
Connect your camera to the bracket as follows:
3
Attach the rubber onto bracket
and screw the camera body onto
bracket.
Make sure that the rubber
is attached onto bracket.
Camera Body
Bracket
Rubber
IDIS Co., Ltd.
For more information, please visit www.idisglobal.com
Dimensions
Unit: mm (inch)
Ø10
64 (2.52)
4-TAP M5, Dp7
70 (2.76)
70 (2.76)
32 (1.26)
4 -
Ø 9.8 (0.39)
32 (1.26)
64 (2.52)
32 (1.26)
4 - Ø 6.3 (0.25)
70 (2.76)
70 (2.76)
90 (3.54)
90 (3.54)
R184.5
R184.5
Ø 52.5 (2.07)
Ø 41 (1.61)
43 (1.69)
44 (1.73)
22 (0.87)
18.6 (0.73)
22.5 (0.89)
24.5 (0.96)
PT 1/2"
3 (0.12)
2 (0.08)
35 (1.38)
3 (0.12)
Ver.1.0
/
