BRAISING PAN
Gas, Power, Tilting
Models: BGMTSE-30 (30 Gallon/114 Liter Capacity) BGMTSE-40 (40 Gallon/152 Liter Capacity)
Model BGMTSE-30
Page KB-
Southbend’s versatile Tilting Braising
Pan can be used more often and in more
ways than any other type of cooking equip-
ment. One vessel cooking is yours by uti-
lizing the braising pan as a griddle, fry pan,
kettle, oven, thawer and bain marie.
Assembly Structure
Each commercial braising pan has a one-
piece, coved corner, 10-gauge stainless
steel pan with a satin finish exterior and a
polished interior.
The braising pan is heated by bar burners.
The 5/8" thick stainless steel clad bottom
has a polished finish to ensure maximum
ease of cleaning. The unit has stainless
steel, spring assisted cover, for safe, one
handed operation.
The electric tilt assembly is operated by a
switch located on the control panel which
ensures smooth action and precise control
during pouring of pan contents.
NOTE: Tilting may be stopped at any time
without kettle settling back.
Cabinet Base
The cabinet base is modular in design to
match other Southbend cooking equip-
ment and is equipped with 6" stainless
steel legs with hold down feet in rear.
Polished stainless steel doors have mag-
netic latches.
Control System
The electric thermostat ranges from 150°F
to 460°F, and the unit is equipped with an
Electronic Ignition system for burners
Technical Data: listed on the reverse side.
Warranty: One year parts and Labor
Warranty at no extra charge from the date
of purchase.
OPERATION
Natural or LP. gas. Manifold and pilot gas
pressure is 3½" for Natural; 10" for LP. gas.
Incoming gas pressure must not exceed 14"
W.C.
OPTIONS
!
Single pantry faucet with swing spout
! Double pantry faucet with swing spout
! Pan holder
! Steam pan insert
! 220V/1/50 or 60 controls
" INQUIRE TO FACTORY FOR SPECIAL
OR CUSTOM REQUIREMENTS.
Southbend has a policy of continuous
product research and developement. We
reserve the right to change specifica-
tions and product design without notice.
Such revisions do not entitle the buyer
to
corresponding changes, improvements,
additions or replacements for previously
purchased equipment.
JOB_________________ITEM#_____________
SIDE VIEW
FRONT VIEW
NOTE: Not for Scale. For Dimensional Purposes Only.
MODELS:
!
BGMTSE-30
!
BGMTSE-40
1100 Old Honeycutt Rd. • Fuquay-Varina • NC • 27526
##$
$
(800) 348-2558 • (919) 552-9161
Fax (800) 625-6143 • (919) 552-9798
http://www.middleby.com
A MIDDLEBY COMPANY
Form KB-67/68A Printed 08/97, Rev. 07/97
Model A B C D E F G H I J K L M N O P
BGMTSE-30
36" 33" 24" 33½" 9" 12½" 22" 6" 40½" 68" 7½" 7" 18" 4" 42½" 14"
(915) (838) (614) (851) (228) (318) (559) (152) (1029) (1727) (191) (178) (457) (102) (1080) (35.6)
BGMTSE-40
48" 33" 24" 43½" 9" 12½" 22" 6" 40½" 68" 7½" 7" 18" 4" 44" 19"
(1220) (838) (614) (1105) (228) (318) (559) (152) (1029) (1727) (191) (178) (457) (102) (1118) (483)
Model
Gas BTU/Hr. KCAL/Hr. Water Column
Type Pressure
BGMTSE-30
Natural 80,000 20,160 min. 7"(178mm)
Propane 80,000 20,160 min.11"(279mm)
BGMSTE-40
Natural 100,000 25,200 min. 7"(178mm)
Propane 100,000 25,200 min. 11"(279mm)
SERVICE CONNECTIONS
Gas Connection (GC): ¾" (19mm) pipe IPS
Electrical Connection (EC): Unless otherwise specified, field wire
electrical connection to be 120V, 60 Hertz, single phase with ground wire.
INSTALLATION
For installation on combustible floors (with 6" legs) and adjacent to com-
bustible walls, allow 6" (150mm) clearance.
INTENDED FOR COMMERCIAL USE ONLY.
NOT INTENDED FOR HOUSEHOLD USE.
A
C
B
D
N
I
G
H
K
O
F
E
J
L
EC
EC
EC
GC
P
M
Electrical Connection
Gas Connection
TOP VIEW
DIMENSIONS ( )=Millimeters
23.5
(597)
Page KB-68A
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI