1
Ltap mini accessories guide
• Open the LtAP mini case by unscrewing the back
screws.
• Disconnect the LTE antenna connectors from the
modem and seal the antenna connector ends with
tape, so they do not short the parts on the PCB.
• Drill holes in the case for ANT1/ANT2 and optionally
for GPS, if an external GPS antenna will be used.
• Screw in the SMA pigtails into the holes and tighten
them.
• Connect the ANT1 SMA pigtail to the modem AUX
connector and ANT SMA pigtail to modem MAIN
connector.
• (Optional) Connect the GPS SMA pigtail to the GPS
ufl connector. Apply some glue/silicone on top of the
pigtail so the ufl connector doesn’t break o during
the movement of the device.
• Close the case and make sure that the pigtail cable
doesn’t get damaged and doesn’t disconnect from
the ufl connector.
• Reinsert the case screws and tighten them.
• Attach the SMA cables to the LtAP mini ANT1/AND2
and tighten them. Attach and tighten the other end of
the cables to the LTE antenna.
• Attach the GPS antenna SMA cable to the GPS SMA
connector on the LtAP mini.
• Mount the LTE antenna to the pole. Mount the GPS
antenna to a metallic surface using the magnet or use
double side tape.
Active GPS antenna
ACGPSA
LTE 1LTE 2
LTE 1 LTE 2
GPS
2x SMA cables
SMASMA
U.fl - SMA female pigtail
ACSMAUFL
mANT LTE 5o
MTAO-LTE-5D-SQ
-
1
MikroTik LtAP mini 4G kit User guide
- Type
- User guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Aruba AP-105-MNT User manual
-
Sierra Wireless AirLink GX440 User manual
-
BEC MX-240 Quick start guide
-
Multitech MTSMC-H5-U.R2 User guide
-
Perle IRG5410 LTE Installation guide
-
-
Sixnet Sixnet Series User manual
-
-
Huawei BTS3900C Hardware Description
-
Cisco AIRANT2524DWR User manual