Garmin GDL 82 Installation guide

Type
Installation guide

This manual is also suitable for

1200 E. 151
st
Street
Olathe, KS 66062
913-397-8200
STC SERVICE BULLETIN
© 2018
Garmin Ltd. or its subsidiaries
All Rights Reserved
Except as expressly provided herein, no part of this document may be reproduced, copied, transmitted, disseminated, downloaded or stored in any
storage medium, for any purpose without the express prior written consent of Garmin. Garmin hereby grants permission to download a single copy of
this document and of any revision to this document onto a hard drive or other electronic storage medium to be viewed and to print one copy of this
document or of any revision hereto, provided that such electronic or printed copy of this document or revision must contain the complete text of this
copyright notice and provided further that any unauthorized commercial distribution of this document or any revision hereto is strictly prohibited.
STC Service Bulletin 1769 Page 1 of 3
May 30, 2018 Revision B
NO.:1769 Rev B
TO: All Garmin Aviation Service Centers
DATE: May 30, 2018
SUBJECT: Initial Issuance of STC for Installation of Garmin GDL 82 in Mooney M20( ) Series
STC SA02573SE
CERTIFICATION
AUTHORIZATION: STC SA02573SE (see Approval section for details)
REVISION B: Clarified Description Note
PRODUCTS AFFECTED
STC SA02573SE authorizes the installation of the following on Mooney M20( ) Series aircraft listed on the
TCDS 2A3:
GDL 82
GDL 82 with GPS/WAAS
PURPOSE
The GDL 82 is a remote mounted UAT transmitter designed to be installed in-line between an existing
Mode A/C transponder and its L-Band antenna. The GDL 82 is an ADS-B Out solution that meets 14
CFR §91.225 and §91.227 regulations. The GDL 82 automatically synchronizes with the transponder to
obtain the transponder squawk code, IDENT status (i.e., SPI status) and pressure altitude data. With the
direct in-line connection the transmitted interrogation can only be received by the interfacing ownship
transponder.
The GDL 82 receives ADS-B GPS data from the approved sources below:
Internal GPS/WAAS Receiver
GTN 6XX/7XX series navigators with software version 6.41 (or later) via RS-232 Interface
GNS 4XXW/5XXW series navigators with software version 5.30 (or later) via RS-232 Interface
GNS 480 navigator with software version 2.4 (or later) via RS-232 Interface
STC Service Bulletin 1769 Page 2 of 3
May 30, 2018 Revision B
DESCRIPTION
This STC Service Bulletin provides notification of initial issuance of STC SA02573SE, with GDL 82
Mooney M20( ) Series STC Master Drawing List, 005-01008-A1, Revision 1. This STC approves the initial
airworthiness of the GDL 82 UAT (978 MHz) Datalink Transmitter and installation in Mooney M20( ) series
aircraft listed on TCDS 2A3.
NOTE
The GDL 82 can be installed in other aircraft not covered by this STC without the need for
additional FAA approved data, provided the installation is conducted in accordance with
FAA Policy Memorandum, Installation Approval for ADS-B OUT Systems, dated March 2,
2016. For specific installation and approval procedures in aircraft not covered under this
STC, see AFS-300 Major Repair and Alteration Data Approval, Online Job Aid, September
2017, with Technical Paper AFS-360-2017-1, Installation of ADS-B Out Equipment.
At the time of this publication, these FAA documents can be found at this URL:
https://www.faa.gov/nextgen/equipadsb/installation/.
COMPLIANCE
Optional: This STC Service Bulletin may be incorporated at the owner’s discretion and is not warranty
reimbursable.
APPROVAL
The modifications described in this service bulletin are FAA-approved for installation in accordance with
STC SA02573SE, GDL 82 Mooney M20() Series STC Master Drawing List, 005-01008-A1, Revision 1 or
later FAA-approved revision. Refer to the REFERENCES section to determine all currently approved
installations and software versions for this STC.
NOTE
This STC does not provide the data, and neither is it the basis of the airworthiness approval
for antenna installation. Installation of the GPS/WAAS or L-Band antennas, as part of GDL
82 system, requires a separate airworthiness approval.
DOCUMENTATION CONSIDERATIONS
Upon completion of this alteration the following documents are required to be issued to the aircraft
operator/owner before the aircraft is returned to service.
Table 1 - Documentation to be Provided to Owner/Operator
Document
Number
Revision
Description
190-01810-11
1
Instructions for Continued Airworthiness & Maintenance Manual, GDL 82
Mooney M20() Series STC
190-01810-12
1
Airplane Flight Manual Supplement for the Garmin GDL 82 Mooney M20
Series
STC Service Bulletin 1769 Page 3 of 3
May 30, 2018 Revision B
REFERENCES
Table 2 - References
Document
Number
Revision
Description
005-01008-A1
1
GDL 82 Mooney M20() Series STC Master Drawing List
190-01810-10
1
GDL 82 Mooney M20() Series STC Installation Manual
190-01810-11
1
Instructions for Continued Airworthiness & Maintenance Manual, GDL 82
Mooney M20() Series STC
190-01810-12
1
Airplane Flight Manual Supplement for the Garmin GDL 82 Mooney M20
Series
Referenced documents are available at dealers.garmin.com.
MANPOWER
Not estimated.
WARRANTY INFORMATION
This modification is not warranty reimbursable.
MODIFICATION INSTRUCTIONS
Refer to the Installation Manual, GDL 82 Mooney M20() Series STC Installation Manual, 190-01810-10
for modification instructions associated with this STC.
MATERIAL INFORMATION
The STC documentation is downloadable from the Garmin Dealer Resource Center at
dealers.garmin.com.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Garmin GDL 82 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI