Table Stand and Cable organizers Screws
4mm
Cable organizer lids Hex keys
M5x12
(4 pcs)
PanaCast 50 Video Bar System
Table Stand
Unscrew and remove the cable cover.
1
2Attach the video bar to the Table Stand. Screws are not required.
Use the cable organizers on the front and back of the Table
Stand to keep the cables neat and tidy.
(The cable organizer on the back is for cables to the monitor, power and ethernet.
The cable organizer on the front is for cables to laptops and BYOD.)
3
HDMI IN HDMI OUT2 HDMI OUT1 USB-A
USB-C
ETHERNET
POWER
3.5MM JACK
USB-A
4Screw the cable organizer lids to the Table Stand using the
supplied screws.
Screw the cable cover to the video bar using the supplied screws.
5
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Eaton Linx Installation guide
-
Case Logic EKS-103 Datasheet
-
APC NetShelter SX 42U Specification
-
3com III User manual
-
Hosa Technology GTR020R Datasheet
-
Stanley 1-93-335 User manual
-
3M ST MM Plate, 12 Port, Operating instructions
-
CompanionLink Software Linea 32 Owner's manual
-
Sharp ORGANIZER Link4 User manual
-
