Phoenix Gold ZDAPV1 Operating instructions

MAX

INSTALLATION MANUAL ZDAPV1

Step by step Instruction

Notes

Connect multiconnector to ampliﬁer & Connect the Yellow wire to +12 Volt and black cable to GND

20-way black connector

Connect the ISO connector together ﬁrmly

These terminal can also be connected to

battery and ground for better performance

Locate the Original ampliﬁer under right from seat and disconnect the Original wires from the ampliﬁer and

connect the leads from the amp to the ampliﬁer and the other end to the original connector

Now start the system and upload the preferred Volvo setup ﬁle from Phoenix gold EU Website

https://phoenixgold-eu.com/downloads/

VOLVO POWER UPGRADE

COMPLETE PLUG N PLAY SOLUTION

FOR S,V, XC 2016 >"

Thank you for buying this upgrade kit. We think you

will love this product and we hope that you will enjoy

the extra performance this will give you!"

Installation should take about 10min please mount

ampliﬁer as you see ﬁt but we recommend it to be

mounted in back of the car. No cutting oﬀ any wires

just plug connectors in and load the software and you

are good to GO!"

PS. If you wish to give the optimal performance to the ampliﬁer

you can connect thicker cables on the +12V and GND connectors

for the amp. From the battery. This will improve performance

further.