2. peak design
  3. M-MM-AA-BK-WEB-1
M-MM-AA-BK-WEB-1

peak design M-MM-AA-BK-WEB-1 Operating instructions

  • Hello! I've reviewed the Motorcycle Stem Mount instructions and I'm ready to answer your questions. This document details how to install the mount on your motorcycle's steering stem, including information about its vibration dampener, adjustable arm and use of expansion plugs. It also covers how to attach and detach your phone using the SlimLink system. Let me know what you'd like to know!
  • What type of handlebars is the Stem Mount compatible with?
    Does the mount come with a tool for installation?
    What should I do if the plug is not snug once expanded?
    How do I attach the phone to the mount?
    Do I need to press both release buttons to remove the phone?
INSTALLATION
1. The Stem Mount is compatible with
hollow steering stem nuts, typically found
on clip-on style handlebars. If applicable,
remove the plastic cap on your stem or
replace the closed top nut with an open
top nut.
2. Loosen both Arm Screws so that the
Arm and SlimLink™ Mount Head can
pivot out of the way of the Base Screw for
the install.
3. Place the Stem Mount in the steering
stem. Tighten Base Screw with the Hex
Key. Max torque: 4 N•m.
Note: If the Plug is not snug once
expanded, change to the Large
Expansion Plug. See 3b.
MOTORCYCLE STEM MOUNT
INSTRUCTIONS
more info
pkdsn.com/motostemmount
WHAT’S IN THE BOX
requires Peak Design Case
not included
Standard
Expansion Plug
13-20mm
(comes installed)
Large
Expansion Plug
20-26mm
SlimLink™
Mount
Head
Mount
Arm
Base
Screw
Locking
Teeth
Release
Button x2
You only
have to
press one
to release
phone!
Hex Key
Stay safe. Do not interact with or remove
phone from the mount while in motion.
!
Attach/Detach Phone
To attach, place phone on mount and listen for “click” to
ensure phone is locked. Requires Peak Design Case (sold
separately).
To remove, push just one of the Release Buttons and pull
phone outward.
3b. To install the Large Expansion Plug,
loosen the Base Screw and remove the
Standard Expansion Plug. Replace with
the Large Expansion Plug and tighten
Base Screw.
4. Set the Arm to your desired angle.
Tighten both Arm Screws to lock the Arm
in place. Max torque: 4 N•m.
5. Before riding, slowly turn handlebars
fully left and right with and with phone
mounted to confirm no interference with
nearby components (e.g. gas tank,
fairings, gauges) Reposition and recheck
if necessary.
Warning! Screws may loosen over time due to vibration.
Periodically check screw tightness.
Pivot
The Arm and SlimLink™ Mount Head pivot to allow perfect
positioning for your bike.
Pro Tip: Rotate the base 180° to allow more reach if needed.
USE
Vibration Dampener
The Stem Mount includes a
Vibration Dampener designed
to prevent engine vibration
from impacting your phone
camera. By design, the
Vibration Dampener allows the
SlimLink™ Mount Head some
wiggle.
/