2. peak design
  3. M-MM-AB-BK-WEB-1
M-MM-AB-BK-WEB-1

peak design M-MM-AB-BK-WEB-1 Operating instructions

  • I have reviewed the provided instructions for the Peak Design Motorcycle Bar Mount. This document details the features, installation process, and usage guidelines for the mount, which includes a vibration dampener and various mounting options. I am ready to answer any questions you might have about this device.
  • What type of phone case is required for this mount?
    Can I mount my phone without the arm?
    How do I remove the phone from the mount?
    Do I need to use both of the release buttons to remove the phone?
Handlebar
Clamp
Screw
Mount
Arm
SlimLink™
Mount Head
Locking
Teeth
Release Button x2
You only have to press
one to release phone!
MOTORCYCLE BAR MOUNT
INSTRUCTIONS
more info
pkdsn.com/motobarmount
1. Use provided Hex Key to
remove the screw on the
Handlebar Clamp. Next,
loosen both screws on the
bottom of the Arm such that
the arm pivots at two points.
2. Select a location for the
Bar Mount. Rotate the Arm
and Head to desired angle,
tighten Arm in place. Then,
tighten Handlebar Clamp.
See Armless Mount Option
for a low-profile mount
option.
3. If needed, add a Collar Set
to fit your handlebars. Push
each Collar half into the
corresponding notches on
the Handlebar Clamp.
Note: With no collar the
mount fits 1-1/4” bars.
4. Lastly, tighten the
Handlebar Clamp Screw to
secure the mount in place.
Max torque: 4 N•m.
GET TO KNOW YOUR MOUNT
requires Peak Design Case
not included
*31.8mm (1 1/4”)
with no collar
Collar
28.6mm (1 1/8”)
Collar
25.4mm (1”)
Collar
22.2mm (7/8”)
Hex Key
INSTALLATION
1. Detach the Mount Arm by removing both screws from the
underside of the Arm.
2. Reinstall the SlimLink™ Mount Head directly to the
Handlebar Clamp.
3. Mount in the armless configuration per the installation
instruction. Jump to step 3 on installation instructions and
proceed.
Warning!
Screws may loosen over time due to vibration. Periodically
check screw tightness.
ARMLESS MOUNT INSTALLATION
Mount direct to handlebar with no Mount Arm
Stay safe. Do not interact with or remove
phone from the mount while in motion.
!
Attach/Detach Phone
To attach, place phone on mount and listen for “click” to
ensure phone is locked. Requires Peak Design Case (sold
separately).
To remove, push just one of the Release Buttons and pull
phone outward.
Release
Button
USE
Vibration Dampener
The Bar Mount includes a
Vibration Dampener designed
to prevent engine vibration
from impacting your phone
camera. By design, the
Vibration Dampener allows the
SlimLink™ Mount Head some
wiggle.
/