USE INSTRUCTIONS – WATER HEATER PANS
GENERAL
• Recommended for use with electric water heaters only
• Be sure to purchase drilled (drain hole pre-drilled in the side) or undrilled as desired
WATER HEATER PAN INSTALLATION
• Place water heater pan under the area where the water heater is to be placed
• Set water heater down onto the center of pan without putting any weight or force on the sides of the pan
INSTALLING DRAIN HOSE ADAPTER
• Remove circular nut and rubber O-ring from drainhose adapter
• Install drain hose adapter with threaded side through to inside of pan
• Place the O-ring on the threaded side of adapter (inside of pan) and slide it to the pan inside wall
• Hand-screw the circular nut until the nut is firmly up against the O-ring and inside wall of the pan (hand tight)
• Attach hose (not included) to the outside of the drain adapter, with appropriate cement or glue and run hose to a
terminus per your local building code
PLEASE AVOID
• Avoid setting the water heater on the edge of the pan or it may crush the pan
• Avoid stepping on the pan