Ningbo OR1117-PAD User manual

Brand: Ningbo

Model: OR1117-PAD

Type: User manual

Ningbo OR1117-PAD is a wireless charging pad that allows you to conveniently charge your smartphone or other compatible devices without the need for cables. Simply place your device on the charger and it will begin charging automatically. The charger is compatible with a wide range of devices that support wireless charging, and it delivers a fast and efficient 5W charging output. It also features safety protections to prevent overcharging and overheating, ensuring the safety of your devices during the charging process.

Wireless charger

General information:

Use steps

Warning

1. Product must be used as required, otherwise could cause a fire or other

dangerous risk.

2. Before using check if the parameters of power adapter and wireless charger

are compatible.

3. Store and use in room temperature and dry environment.

4. People who use some medical devices should be careful when using

wireless charger.

Instruction Manual

Model: OR1117-PAD

Description: Wireless Charging Pad 5W

You can easily charge your smartphone wirelessly

If your phone supports wireless charging, just place it on the charger.

If not, complete the phone with wireless receiver.

Charging time may vary.It's based on the device’s battery capacity,charge level,

the age of the battery and the temperature in the surrounding area.

Devices may get warm during charging; they will gradually cool down after they

are fully charged.

Connect wireless charger and power adapter with micro USB cable. Place the

smartphone or other device on the charger and adjust position to charge area.

The device will start to charge; when finished unplug the charger.

SIZE:7X7CM/PAGE

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

Note: Changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate this device.This

equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation.This

equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However there is no guarantee that

interference will not occur in a particular installation. lf this equipment does cause

harmful interference to radio or television reception which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment to an outlet on a circuit different from that to which the

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Ningbo OR1117-PAD User manual

Ningbo OR1117-PAD User manual

Ningbo OR1117-PAD User manual

Other documents