2. CORONA
  3. R6FA-SB

CORONA R6FA-SB User manual

  • Hello! I have reviewed the user manual for the Corona R6FA-SB receiver and FUTABA T14SG controller. This document provides instructions on how to connect a camera to the receiver and configure the controller for remote zoom function using the SG stick. I'm ready to answer your questions about setting up and using these devices based on the information provided in the manual.
  • What receiver is used as an example in the document?
    Which controller is used as an example for the setup?
    What is used to control zoom?
1、connect cam with receiver
Take Corona R6FA-SB as an example, you can use other receiver, but need to adjust to PWM
mode, for your receiver, please check the receiver manual.
Connect PWM signal cable to corresponding receiver channel, GND to GND
2 Controller Setup
In this example，we connect camera to receiver CH5, controller setup as follows:
Take FUTABA T14SG as an example
1. Frequency match according to receiver manual
2. Setup controller as the pics
3. Map CH5 to the button, we map CH5 to SG stick in this example, you also can use other
channel for mapping.
4. Remote control zoom
Use SG stick to control zoom, switch SG stick to down, cam is default 1x zoom, switch SG stick
middle, cam is 10x zoom.
/