Kingston Technology KVR13E9K2/4I Datasheet

Kingston Technology
Brand
Kingston Technology
Model
KVR13E9K2/4I
Category
Memory modules
Type
Datasheet

Kingston Technology KVR13E9K2/4I is a kit of two 256M x 72-bit (2GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM), 1Rx8, ECC, 256M x 8-bit FBGA components per module. Total kit capacity is 4GB. The SPDs are programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V.

With the addition of Kingston Technology KVR13E9K2/4I to your system, it'll gain a significant performance boost. The module operates at a frequency of 667MHz fCK for 1333Mb/sec/pin. It features 8 independent internal banks, programmable CAS latency, additive latency, CAS write latency (CWL) and 8-bit pre

Kingston Technology KVR13E9K2/4I is a kit of two 256M x 72-bit (2GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM), 1Rx8, ECC, 256M x 8-bit FBGA components per module. Total kit capacity is 4GB. The SPDs are programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V.

With the addition of Kingston Technology KVR13E9K2/4I to your system, it'll gain a significant performance boost. The module operates at a frequency of 667MHz fCK for 1333Mb/sec/pin. It features 8 independent internal banks, programmable CAS latency, additive latency, CAS write latency (CWL) and 8-bit pre

KVR13E9K2/4I
4GB (2GB 1Rx8 256M x 72-Bit x 2 pcs.)
PC3-10600 CL9 240-Pin ECC DIMM Kit
DESCRIPTION
ValueRAM's KVR13E9K2/4I is a kit of two 256M x 72-bit (2GB)
DDR3-1333 CL9 SDRAM (Synchronous DRAM), 1Rx8, ECC,
Intel
®
Compatibility Tested, memory modules, based on nine
256M x 8-bit FBGA components per module. Total kit capacity
is 4GB. The SPDs are programmed to JEDEC standard latency
DDR3-1333 timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses
gold contact fingers. The electrical and mechanical specifica-
tions are as follows:
FEATURES
• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 667MHz fCK for 1333Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
• Bi-directional Differential Data Strobe
• Thermal Sensor Grade B
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB: Height 1.18” (30mm), single sided component
Document No. VALUERAM1211-001.A00 05/11/12 Page 1
Memory Module Specifi cations
SPECIFICATIONS
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.)
Refresh to Active/Refresh 160ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 36ns (min.)
Maximum Operating Power 2.430 W* (per module)
UL Rating 94 V - 0
Operating Temperature 0
o
C to 85
o
C
Storage Temperature -55
o
C to +100
o
C
*Power will vary depending on the SDRAM used.
Continued >>
MODULE DIMENSIONS:
Document No. VALUERAM1211-001.A00 Page 2
Units: millimeters
30.00
18.80
15.80
11.00
8.00
0.00
133.35
0.00
54.70
TECHNOLOGY
  • Page 1 1
  • Page 2 2

Kingston Technology KVR13E9K2/4I Datasheet

Kingston Technology
Brand
Kingston Technology
Model
KVR13E9K2/4I
Category
Memory modules
Type
Datasheet

Kingston Technology KVR13E9K2/4I is a kit of two 256M x 72-bit (2GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM), 1Rx8, ECC, 256M x 8-bit FBGA components per module. Total kit capacity is 4GB. The SPDs are programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V.

With the addition of Kingston Technology KVR13E9K2/4I to your system, it'll gain a significant performance boost. The module operates at a frequency of 667MHz fCK for 1333Mb/sec/pin. It features 8 independent internal banks, programmable CAS latency, additive latency, CAS write latency (CWL) and 8-bit pre

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents