Nuvico EasyView WDR Series Installation guide

Brand: Nuvico

Model: EasyView WDR Series

Category: Security camera accessories

Type: Installation guide

This manual is also suitable for

Flush Housing w/ Surface Mount Plate

INSTALLATION MANUAL

™

Indoor Wall Mount Pedestal Mount Junction BoxOutdoor Wall Mount

Before installing and using the camera, please read this manual carefully. Be sure to

keep it handy for later use. This installation manual covers the following models listed

below. Any difference in features for these models are indicated where necessary.

Note: Installation of t his product should be made by a qualified technician and should

conform to all local codes.

Step-1

As shown below, hold the Gimbal base firmly in place with one hand.

Step-2

Gently press Points A & B with other hand and pull the Gimbal cover off.

Step-3

Step-4

Replace the Gimbal cover by gently pressing back onto the Gimbal base.

Gimbal Base

Point-A

Point-B

Gimbal Cover

EasyView Dome Cameras have vari-focal lens integrated inside the Gimbal. If you

require to make focal/focus adjustments, the Gimbal cover needs to be removed

temporarily.

The Gimbal mechanism yields maximum rotation and placement as shown below.

Pan

Tilt

Horizontal Rotation

355º

85º

355º

• Torx Wrench - For Vandalproof Domes

Model #: T20

Length: 2

1/2"

Thickness:

1/8

• Assembly Screws - For Vandalproof Domes

These screws are used to affix dome cover to flush housing.

Model #: Philips M4x10

Qty: 3

Length: 10mm

Thickness: 4mm

• Assembly Screws - For Indoor Domes

These screws are used to affix dome cover to flush housing.

Model #: Philips ST4x12

Qty: 3

Length: 12mm

Thickness: 4mm

• Mounting Screws - For Vandalproof & Indoor Domes

These Screws are used to mount both surface mount plate or flush housing

to a sturdy surface. If necessary, use the anchors included in the package.

Model #: Philips ST4x30

Qty: 4

Length: 30mm

Thickness: 4mm

• Anchors - For Vandalproof & Indoor Domes

Qty: 4

Length: 30mm

Thickness: 6mm

14499

h M

Surface M

op Vie

147

108

89 121

83.1

109

143

112

109

Dimensions

(UNIT: mm)

REMINDER

Do not aim the camera directly into the sun.

1. Lens

2. Power Input Connector

12VDC/24VAC Dual Voltage

3. Video Output Connector - BNC

4. Service Monitor Output Connector

Use Cable CA-SMC30.

5. Camera Control Board

6. Safety Wire

7. Bubble

8. Dome Cover Ring

9. Flush Mount Base

10. Surface Mount Plate

11. Assembly Screws

Philips M4x9(Indoor), Torx M4x9(Vandalproof)

12. Assembly Screws

Philips ST4x12(Indoor), Philips M4x10(Vandalproof)

13. Mounting Screws

Philips ST4x30(Indoor & Vandalproof)

26.2

ø5.0

ø15

112

109

ST4x30

ST4x12 or M4x10

Surface Mount

Surface Mount TemplateFlush Mount Template

Plastic DowelsPlastic Anchors

Flush Mount

ST4x30

Philips M4x9 or

Torx M4x9

1. Remove dome cover by loosening 3 screws. For indoor domes, use standard Philips

screw driver. For vandalproof domes, use Torx wrench provided with the package.

2. Surface Mount:

Using four ST4x30 screws, mount surface plate to a sturdy surface Using three

ST4x12(Indoor) screws or M4x10(Vandalproof) screws, affix flush mount base to

surface plate.(For flush mount application, disregard this section)

3. Flush Mount:

Using four ST4x30 screws, affix flush mount base to a sturdy surface

Screws UNC 8-32 x 0.75

3/4"

Pipe

Note: Screws required for electrical junction boxes are not supplied with the package.

These screws are readily available at local electrical supply stores.

Either flush mount or surface mount application, pre-drilled mounting holes on EasyView

Domes accommodate various electrical junction boxes, making installation easy and less

time consuming.

12VDC/24VAC

CCTV Monitor

• Power connection - Requires 12VDC or 24VAC input depending on camera model.

• All camera model are supplied with second video output on the camera module. To use

this feature along with a service monitor, second monitor cable/connector

(Part# CA-SMC30) is required. Contact your distributor or NUVICO Sales Department

for further information.

Service Monitor

CA-SMC30

30cm

Left

Right

Up Right

Down

Service Monitor Output

Adjust Focus

Adjust Angle for Field of View

Remove the Gimbal cover from the Gimbal base

Loosen Zoom & Focus screws and make necessary adjustments as shown.

Field of View: Telephoto( T ) to Wide( W )

Focus: Near( N ) to Far( F )

Replace the Gimbal cover back to the Gimbal base.

Focus

Zoom

Gimbal Cover

Left

Right

Up Right

Down

Use the five key on switch board of the camera.

RIGHT key

LEFT key

UP key

DOWN key

CENTER key

Service Monitor Output

Fan & Heater for EasyView™ Vandalproof Domes

Power Input

Power Consumption (Heater)

Power Consumption (Fan)

Heater ON

Heater OFF

Fan ON

Note: For Fan and Heater operation, 24VAC power input is required.

Current model does not support 12VDC operation.

24VAC

10W

0.7W

at 41ºF (5ºC)

at 59ºF (15ºC)

24 Hours

Assembly Screw

- Philips M2.6x14

- Qty: 1

- Length: 14mm

- Thickness: 2.6mm

Assembly Screw

- Philips M3x6

- Qty: 1

- Length: 6mm

- Thickness: 3mm

Features

Assembly Accessories

Specification

Assembly Screws

Philips M3x6 (1x)

Assembly Screws

Philips M2.6x14 (1x)

Vandalproof EasyView™

Assembly

Fan & Heater Installations & Specifications / CV-FH

187

Contents

Construction

143.4

111.2

100.4

4-ø 11.0

EasyView™

Assembly

Pipe

3/4 Inch

Assembly Screws

Philips M4x10 (3x)

Wall Mount

Teflon tape

Wall

Wall Mount

- Qty: 1

Mounting Template

- Qty: 1

Assembly Screws

- Philips M4x10

- Qty: 3

- Length: 10mm

- Thickness: 3mm

• Aluminum

• Color Options: Ivory or Black

• Weight: 1.4 lb(0.64kg)

Dimensions (UNIT: mm)

Note: Mounting screws are not

supplied with this package.

• Must use specified and regulated 12VDC/24VAC power supply.

NUVICO

Tel: +7 495 234-3212 Fax: +7 495 234-3212

E-mail: [email protected]

www.nuvico.ru

™

Nuvico EasyView WDR Series Installation guide

Brand: Nuvico

Model: EasyView WDR Series

Category: Security camera accessories

Type: Installation guide

This manual is also suitable for

Download PDF

report

Nuvico EasyView WDR Series Installation guide

This manual is also suitable for

Nuvico EasyView WDR Series Installation guide

Related papers

Other documents