Alpine Industries 485 User manual

Stainless Steel Brushed Vertical Toilet Paper Holder

Item# 485

Installation

1. Using stud finder, locate stud behind wall and mark with pencil at the height you would like to install your toilet

paper holder.

2. Place the mounting end of the toilet paper holder over your marked stud and mark the drill holes with your pencil.

3. Using a drill, place holes into the wall according to the markings you made in step 2.

4. Attach toilet paper holder by inserting screws in each of the holes with item attached to wall.

5. Tighten screws only after all of the screws have been inserted using a screw driver.

6. Close flange cover over mounting hardware.

7. To affix toilet paper roll: unscrew upper portion of the holder from the base attached to wall. Use standard sized

toilet paper roll.

Tools Needed:

Drill Screw Driver Pencil

Drill Bit Stud Finder