778-11919A© 2011 12A-A26
Note: Refer to your Operator’s Manual
for instructions on attaching the grass collector.
Remove the wing nuts and carriage bolts A.
securing the upper handle to the lower
handle.
A
Pivot the upper handle
upward.
Note: Refer to your Operator’s Manual
for instructions on attaching the grass collector.
Insert the T-bolts removed in Step 1B A.
through the handle brackets to secure
the handle in place.
Hold blade control handle against upper handle. A.
Slowly pull starter rope handle from engine and B.
slip starter rope into the rope guide.
Tighten rope guide wing knob.C.
Use cable tie to secure cables to lower handle.D.
A
B
C
D
Starter
Rope Handle
Blade Control Handle
Wing Nuts
Remove T-bolts from B.
the handle brackets.
Pull upward on the
handle until the holes
in lower handle line
up with the holes in
the handle bracket.
A
B
B
T-Bolt
Secure upper handle B.
to lower handle with
wing nuts (on outside)
and carriage bolts
removed Step 1A.
A
B
1
4
2
5
3
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U