Mr. Beams MB 723 Installation guide

Brand: Mr. Beams

Model: MB 723

Type: Installation guide

Mr. Beams MB 723 is a wireless motion sensor LED stick-anywhere light that provides convenient illumination in dark areas. It features a motion sensor that activates the light when it detects movement up to 15 feet away, and an auto shut-off that turns the light off after 30 seconds of inactivity. With its bright LED light covering up to 10 square feet, it's perfect for closets, cabinets, pantries, and other small spaces. Easy to install with included double-sided tape or screws, the MB 723 operates on 4 AA alkaline batteries (not included).

Stick Anywhere Light Features:

Motion/Light Sensor: Light instantly turns on when it

detects motion from up to 15 feet away. The light sensor

conserves battery life by preventing the light from

activating in daylight.

Auto Shut-o: Stick Anywhere Light shuts o

automatically after 30 seconds if no motion is detected.

Bright LED: 20 Lumens covers up to 10 sq ft.

32333 Aurora Rd. Suite 100 Solon, OH 44139

877.298.9082

Installation Instructions

Wireless Motion Sensor LED Stick Anywhere Light

MB720-723

• 1 Small Screwdriver

• 4 AA-Cell Alkaline Batteries (per light)

• Wireless LED Stick Anywhere Light

• 2 Screws & Double Sided Tape

• Mounting Bracket

LED Light

Motion & Light

Sensor

NOTE: Light sensor only allows light to activate in darkness. We recommend you test in a dark room or closet.

What you need to install:

Thank you for purchasing the Mr Beams

Stick Anywhere Light. We are committed to

eliminating darkness using the latest in

Light-Emitting Diodes (LEDs). LEDs are the most

ecient and durable light sources available. We

are certain that your light will contribute to a safer

environment and provide light where you need it at

a very reasonable cost.

What is included per light:

www.mrbeams.com

1. Remove mounting bracket from back of light.

Remove battery door by turning 2 thumb screws

counter clockwise.

2. Insert 4 Fresh AA alkaline batteries.

5. Slide light onto mounting bracket

attached to wall.

4. Mount bracket to wall with double sided tape,

holding for 10 seconds or install with 2 small

screws. Note: This is a strong adhesive that

may cause damage to mounting surface. Please

consider your location before mounting.

3. Close battery door and replace

thumb screws.

Tips:

•

Use only new alkaline AA-Cell batteries with 1.5V rating.

•

Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.

•

Install batteries with polarity in correct position.

•

Light may activate when batteries are inserted. Simply take light into a dark room. Allow

batteries to settle, then test activation.

•

If your light will not turn o, it means that it is time to replace the batteries.

* 1 year limited warranty. Visit site for details.

* Visit our website to view installation video.

Battery Caution:

1) Do not mix old and new batteries

2) Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium)

or (Nickel Metal Hydride) batteries

3) Do not dispose of batteries in re

4)Batteries should be recycled or disposed of as per state and local guidelines

Mr. Beams MB 723 Installation guide

Mr. Beams MB 723 Installation guide

Mr. Beams MB 723 Installation guide

Related papers

Other documents