Glomar HD-982 Installation guide

ASSEMBLY INSTRUCTION

SKU#60/981/982

NOTE: Please consult a qualified electrician if you are not certain of the installation.

CAUTION: Before starting the installation, disconnect the power by turning off the circuit breaker or by

removing the fuse at the fuse box.

1. Unscrew the Screw Collar Loop from the Nipple in Mounting Strap.

2. Fasten Mounting Strap onto Outlet Box using Outlet Box Screws provided

3. Using two pliers twist open the links at the two ends of the Chain. Hook one link to the Loop and the other

link to the Screw Collar Loop. Close the links.

4. Weave the fixture wires up through the Loop, through the chain, through the Ring, through the Screw

Collar Loop, through the Canopy and through the Nipple in the Mounting Strap.

5. Connect the wire with writing on it to the black wire from the supply circuit. Connect the wire without

writing on it to the white wire from the supply circuit. Cover the connections using Wire Connectors

provided. Tie the ground wires from fixture and from Outlet Box to the Ground Screw on the Mounting

Strap. Position wires back inside Outlet Box.

6. Place the Canopy over the Nipple all the way to the ceiling and tighten the Ring onto the Screw Collar

Loop until the Canopy is held firmly against the ceiling.

7. Screw the Nipple into the Bushing.

8. Install bulbs. (Not included).

9. Place the Decorative Pan, the Glass Shade, the Cover A, the Decorative Cover and Cover B all the way

through the Nipple and tighten them by screwing the Finial.

10. Turn on the power.

A Satco Product

Page is loading ...

Download PDF