AA205800
Air Vents
Service Valve
Vacuum Range
Switch Adjuster
Low Setpoint
for Low Limit
Vacuum Switch
Daily
A. Replace Collection Canister
Midmark collection canisters are designed for
single patient use only. Refer to collection canister
manufacturer directions for replacement.
Maintenance Kits
Vacuum Filter
Order #: 77000796
Includes:
• 1 Filter (Order 2 per Head)
Flushing Solvent
Order #: 77000699
A. Clean Air Vents on Motors
Disconnect power. Wipe with a clean cloth to
remove dust & debris.
Bi-Annually
A. Vacuum Pump Flushing
Vacuum pump(s) can be flushed to remove deposits
which build up on the pump vanes over time.
Removal of these deposits will help to maintain
proper vane performance. Contact Midmark Service
Technician.
B. Adjust Vacuum Setpoints
Adjust vacuum setpoints at initial setup or when
needed. Procedure is located in this guide.
As Necessary
Midmark Corporation
60 Vista Drive
Versailles, OH 45380
Customer Service Phone: 1-800-643-6275 x 8923
Technical Service Phone: 1-800-643-6275 x 8890
Fax: 1-877-725-6495
www.midmark.com
Exhaust
(PM-1 & PM-3) Order #: 77000894
(PM-4) Order #: 77000895
Includes:
Exhaust kit to vent PowerMax to the outside.
Accessories
Disposable Canisters
(1200 cc)
Order #: 002-1882-00
Includes:
• Pkg of 5 Canisters
Surgical Operatory Recovery
Room Package
Order #: 77008037
Includes:
• Pkg of 5 Disposable Canisters (1200 cc)
• DISS Free Flow Regulator
• Outlet Station: Vacuum DISS
• Conductive Tubing - 6’
• Vacuum Slide and Ring
• Replacement Elbow
Annually
A. Replace Vacuum Filter
Procedure is located in this guide.
B. Drain Moisture from Tank
Open service valve to drain any
accumulated moisture in tank.
Low Setpoint..
Adjust Low Limit if system didn’t turn on at 13”Hg.
• Clockwise will decrease reading.
• Counter Clockwise will increase reading.
Vacuum Range..
Adjust vacuum range if system didn’t shut off at 20”Hg.
• Clockwise will decrease reading.
• Counter Clockwise will increase reading.
AA205700
Maintenance Guide
To ensure years of reliable service, follow the
maintenance schedule outlined in this guide.
If service is required, contact your authorized
Midmark dealer.
Dealer (name / phone):
__________________________________
__________________________________
__________________________________
Model Number:
__________________
Serial Number:
__________________
Date of Purchase:
_________________
Annual Maintenance Log
Date: Services Performed: Technician:
_____ _______________________ __________
_____ _______________________ __________
_____ _______________________ __________
_____ _______________________ __________
_____ _______________________ __________
_____ _______________________ __________
_____ _______________________ __________
_____ _______________________ __________
_____ _______________________ __________
_____ _______________________ __________
10542100 Rev. B
© Midmark Corporation 2007
PowerMax
Surgical Suction System
LIMITED WARRANTY
SCOPE OF WARRANTY
Midmark Corporation (“Midmark”) warrants to the
original purchaser its new PowerMax products and
components (except for components not warranted
under “Exclusions”) manufactured by Midmark to be
free from defects in material and workmanship under
normal use and service. Midmark’s obligation under
this warranty is limited to the repair or replacement, at
Midmark’s option, of the parts or the products the
defects of which are reported to Midmark within the
applicable warranty period and which, upon examina-
tion by Midmark, prove to be defective.
APPLICABLE WARRANTY PERIOD
The applicable warranty period, measured from the
date of installation for the original user, shall be:
• PowerMax Surgical Suction System: Two (2) years
or 1,500 usage hours (whichever comes first)
EXCLUSIONS
This warranty does not cover and Midmark shall not be
liable for the following: (1) repairs and replacements
because of misuse, abuse, negligence, alteration,
accident, freight damage, or tampering; (2) products
which are not installed, used, and properly cleaned as
required in the Midmark “Installation” manual and or
“maintenance” guide for this applicable product; (3)
products considered to be of a consumable nature; (4)
accessories or parts not manufactured by Midmark; (5)
charges by anyone for adjustments, repairs, replace-
ment parts, installation, or other work performed upon
or in connection with such products which is not
expressly authorized in writing in advance by Midmark.
EXCLUSIVE REMEDY
Midmark’s only obligation under this warranty is the
repair or replacement of defective parts. Midmark shall
not be liable for any direct, special, indirect, incidental,
exemplary, or consequential damages or delay,
including, but not limited to, damages for loss of profits
or loss of use.
NO AUTHORIZATION
No person or firm is authorized to create for Midmark
any other obligation or liability in connection with the
products.
THIS WARRANTY IS MIDMARK’S ONLY WARRANTY AND
IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED. MIDMARK MAKES NO IMPLIED WARRANTIES
OF ANY KIND INCLUDING ANY WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR ANY PARTICU-
LAR PURPOSE. THIS WARRANTY IS LIMITED TO THE
REPAIR OR REPLACEMENT OF DEFECTIVE PARTS.
• Shut off power at supply box.
• Vent tank by closing ball valve
and opening service valve.
• Allow pump(s) to cool.
• Unscrew end cap from pump(s).
• Remove filter(s) and o-ring(s).
• Replace with new filter(s) and o-ring(s).
O-ring
Filter Replacement
End Cap
Filter
Service Valve
/
