Boerboel 73014300 Installation guide

1

EPN-5007

To register your product, please visit:

boerboelgatesystems.com

Read all instructions prior to installing product.

Refer to manufacturers safety instructions when operating any tools.

Heavy-Duty Wrap Hinge Kit

Installation Instructions

• English

........................................................

1

• Français

......................................................

7

• Español

.......................................................

13

2

Hinges

Hinge Covers

Screws

Gate

Phillips Head Screwdriver

Safety Glasses

Level

Tape Measure

Wrench

Pencil

#2 Square Drive

3

⁄

3

⁄

3

32

⁄32⁄

" Drill Bit

TOOLS NEEDED:

BEFORE YOU BEGIN:

Vinyl gate posts require an internal support

system for weight-bearing purposes and

therefore wooden inserts or a post stiffener

is required. Post stiffener needs to be

purchased separately.

WARNING:

• Improper installation of this product can result in personal injury. Always wear safety goggles when

cutting, drilling and assembling the product.

• Incorrect installation may cause harm to the gate or individual.

• Not pool code approved.

• Do not allow children to play with the gate.

NOTICE:

• DO NOT attempt to assemble the kit if parts are missing or damaged.

• DO NOT return the product to the store, for assistance or replacement parts call: 1-800-336-2383.

Top View of Routed Post

Fence

Purchased

Metal Stiffener

Component list:

QTY Description

2

Hinges

4

Hinge Covers

24

1

⁄

1

⁄

1

2

⁄2⁄

" #2 Square/Phillips Combo

Self-Tapping Screws

3

Upright

180º

Rail

Determine

location and gate

opening before

installing fence.

Fig. 1

Determine Gate Opening:

Gate opening is determined by width of gate plus

clearance for hinge (

1

⁄

1

⁄

1

2

⁄2⁄

") plus clearance for latch/drop

rod (Fig. 1) (see latch instructions for details).

1

2

Fig. 2

Fig. 3

Installing the Hinge:

Install the hinge on the rail/gate upright (Fig. 2).

The gate can be adjusted to swing 180 degrees with

either a manual or self-closing feature (Fig. 3).

NOTE:

Pilot holes should not be drilled all the way through

gate upright or rails. Mark a pilot hole using the

hinge and drill with

3

⁄

3

⁄

3

32

⁄32⁄

" bit. Also drill pilot holes on

short side of hinge.

3

Mount Hinges on Gate:

Mount both hinges to the gate using (6) 1

1

⁄

1

⁄

1

2

⁄2⁄

" #2 square/

phillips combo screws per hinge (4 on front of hinge and

2 on side) (Fig. 4).

NOTE:

To ensure performance on any gate, additional  ller

may be required.

Cut two 2" spacer blocks to help support the gate

prior to installing hinges to post.

Fig. 4

4

5

Mount Gate to Post:

Set the gate level to the post and mark pilot holes on

the gate post. The slotted screw holes on the inside of

the post attachment allow for vertical adjustment. It is

recommended to pre-drill and install the inside screws

before installing the front screws. (6) 1

1

⁄

1

⁄

1

2

⁄2⁄

" #2 square/

phillips combo screws per hinge (3 on front of hinge and

3 on side) (Fig. 5 & 6).

NOTE:

To ensure superior gate performance for vinyl

gates, make sure gate posts use either an

aluminum gate post insert or wood blocks at both

hinge locations.

Adjust the hinge width or position to the gate post using

the four nuts located where the hinge attaches to the

rail (Fig. 7).

Fig. 5

Fig. 6

Fig. 7

5

6

7

NOTE:

HINGE TENSION IS PRE-SET AT THE

FACTORY

AND USUALLY

DOES NOT REQUIRE

ADJUSTMENT. If you wish to change tension

setting/gate swing speed, or completely disable

the self-closing feature, please see the following:

Hinge tension adjustment

a.) Hold the tension adjustment bolt

with an

11

⁄

11

⁄

11

16

⁄16⁄

" wrench (Fig. 8).

b.) While holding the tension adjustment bolt,

loosen the locking nut with a

5

⁄

5

⁄

5

8

⁄8⁄

" wrench (Fig. 8).

NOTE:

DO NOT release the tension adjustment bolt

at any time during the adjustment.

c.) Following the indicators on the + or - sticker on

the hinge barrel, turn the tension adjustment bolt

toward the + to tighten, or toward the - to loosen

(Fig. 9).

DO NOT adjust by more than 1⁄4 turn, unless you

want to disable the self-closing feature.

- Self-closing feature can be disabled by

loosening the tension adjustments bolt one

full turn.

- Do not over-tighten or over-loosen the

tension adjustment bolt, as this may damage

the tension spring.

d.) Re-tighten the locking nut when you have achieved

the desired setting.

Once gate is aligned and adjusted correctly, snap on

decorative hinge covers (Fig. 10 ).

Fig. 8

Fig. 10

Locking Nut

Tension Adjustment Bolt

Fig. 9

+ or - Sticker+ or - Sticker

6

Subject to the conditions and limitations set out below, Barrette Outdoor Living

warrants that for so long as the original purchaser of a product manufactured by

Barrette Outdoor Living owns that Boerboel Manual Hardware (the Product) it will be

free from all defects due to faulty design, materials or workmanship.

If a defect in the Product appears the purchaser must advise Barrette Outdoor Living

within 14 days of discovering the defect and return the defective item, comprising

either the Product or a defective component of the Product (the ltem), to

Barrette Outdoor Living, freight prepaid, together with proof of purchase whereupon

Barrette Outdoor Living will, at its option and cost, repair or replace the defective

ltem with the same or an equivalent Product or component. Barrette Outdoor Living

will not be liable for labor or any other costs associated with the dismantling, return

or reassembly of the Product or any frame or structure to which it is af xed.

This warranty does not apply in respect of defects due to or arising from:

(a) normal wear and tear;

(b) the failure to follow any procedures speci ed or recommended by

Barrette Outdoor Living for the installation, operation and maintenance of

the Product;

(c) any act or circumstance beyond Barrette Outdoor Livings control including

tampering, unauthorized repairs, misuse, abnormal use, abuse, accident,

damage after delivery to the consumer, damage caused by events beyond

human control including but not limited to damage caused by animals or

natural events, surface tarnishing and/or damage to components caused by

corrosion or other environmental conditions;

(d) any defect of or in any framework or material supporting the Product; or

(e) the faulty workmanship of any person other than Barrette Outdoor Living,

including the installer of the Product.

This warranty is personal to the original purchaser of the Product or to the  rst

consumer where the Product has been installed by a contractor for the bene t

of the consumer and may not be assigned without Barrette Outdoor Living’s prior

written consent.

This warranty gives you speci c legal rights which are in addition to, and do not

replace, other rights and remedies you may have available to you by law and which

may vary from state to state.

Except as expressly granted in this warranty or where to do so would contravene

a statute:

(a) all other warranties, conditions and representations, whether express or

implied by general law, statute or custom, in relation to the Product and its

quality,  tness for purpose and suitability are expressly excluded; and

(b) Barrette Outdoor Living’s liability is excluded for all other loss, damage or

injury of any kind whatsoever (including any direct, indirect or consequential

loss or damage, loss of pro ts or loss of opportunity) arising in connection

with the Product, or the supply, condition or use of the Product, including as

a result of any negligence, misrepresentation, or other default on the part of

Barrette Outdoor Living, its of cers, employees, or contractors or otherwise.

For any speci c questions about the Barrette Outdoor Living Warranty or to make a

warranty claim please contact Barrette Outdoor Living by visiting our website

www.boerboelgatesystems.com, emailing or calling 1-800-336-2383.

To begin your warranty coverage and register your Boerboel Manual Hardware

product visit: www.boerboelgatesystems.com. Retain manual and your dated sales

slip for future reference or warranty claims.

Limited Lifetime Warranty

Page is loading ...

BARRETTE OUTDOOR LIVING

7830 FREEWAY CIRCLE

MIDDLEBURG HEIGHTS, OHIO 44130

TEL: (800) 336-2383

WWW.BOERBOELGATESYSTEMS.COM

Boerboel 73014300 Installation guide

This manual is also suitable for

Boerboel 73014300 Installation guide

in other languages

Related papers

Other documents