Tile Redi RNTH1620S-20D Installation guide

Brand
Tile Redi
Model
RNTH1620S-20D
Type
Installation guide

This manual is also suitable for

Copyright © 2013. Tile Redi Sales, LLC. All Rights Reserved 1
Tile Redi® Installation Guide
Redi Niche® Recessed Shelves
To help you through the REDI NICHE® installation process, we have provided the following Installation Guide which is
intended to provide an easy-to-follow step-by-step process for the installation of your Tile Redi® REDI NICHE®
recessed shelf whether you are a professional or a novice. Please remember to comply with the recommendations
and standards established for such projects from time to time by the National Tile Council of North America, Inc.
INSTALLATION INSTRUCTIONS FOR REDI NICHE®
Overview: first, we describe how to frame the niche: (1) in an existing finished wall, and (2) in a newly constructed
wall. Then we detail the rest of the steps: installing horizontal framing, screwing the niche into the framing, installing
the drywall (or backer board for a shower) around the niche, waterproofing the gap between the niche flange and
the backer board with a bead of silicon, and finally tiling the niche and wall.
1. Framing REDI NICHE® into an existing finished wall (if new construction, skip to paragraph 2):
a. Locate and mark the center of adjacent framing studs using a stud finder or by tapping the wall.
b. Draw a level line between the two wall studs.
c. Place the niche between the two marked studs with the flange walls flush against the wall and trace the
outline of the niche on the wall. Be sure the top and bottom lines are level.
d. Cut out the wall board along the traced lines between the two studs using a drywall saw and utility
knife.
2. Measure the distance between vertical studs. (Please note that the distance between the center lines of 2
adjacent studs generally is 16 inches and the niche is designed for that condition.)
a. If the distance is greater than 16 inches, attach vertical framing to one or both of the vertical studs to
accommodate the size of the niche.
b. If less than 16 inches, widen the framing to accommodate the niche.
3. Measure and cut top and bottom horizontal support framing to a length which permits each to run between
and to be fastened to both vertical studs.
4. Level and mechanically fasten the top and bottom horizontal support brackets to both adjacent vertical
studs so that the vertical dimension between the horizontal support framing matches the vertical dimension
of the predrilled fastening holes on the REDI NICHE® flange.
5. Place the REDI NICHE® in between the framing.
6. Level and mechanically fasten the REDI NICHE® using one framing screw in each pre-drilled hole.
7. Install your drywall or tile backer board around the REDI NICHE® so it’s in accordance with industry
standards.
8. Take 100% waterproofing silicone and seal the gap between the wall board and the REDI NICHE® and each of
the screw holes.
9. Now apply your setting material and set your tile, marble or stone directly to REDI NICHE® surface.
Working with one of our double, triple, or quadruple combination models? Simply place your additional niche(s)
directly beside, above or below each other. We recommend you complete framing for all niches before beginning to
screw any in.
Page is loading ...
Page is loading ...
  • Page 1 1
  • Page 2 2
  • Page 3 3

Tile Redi RNTH1620S-20D Installation guide

Brand
Tile Redi
Model
RNTH1620S-20D
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents