2. Speakman
  3. SA-1402

Speakman SA-1402 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Speakman SA-1402 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
SA-1402
SA-1402-BN
SA-1402-PN
92-3332-R1
Place Slide Bar assembly on to wall in the desired
mounting position. Take care that the Slide Bar is
oriented in a vertical position. Using a pencil,
lightly trace outline of end brackets on to wall.
Slide flange off Mounting Bracket. Then loosen set
screw and remove Mounting Bracket from Slide
Bar Assembly.
Mark center of mounting locations (2) with a
pencil.
Drill 1/4” hole in marked locations. If drilling into
tile, be sure to use a drill bit desinated for tile.
If mounting directly into stud or wood wall, secure
lower end bracket to wall with mounting screw
without drilling hole.
Insert Plastic Anchors into drilled hole and press
in until flush with wall. Secure Mounting Brackets
and Flange to wall with Mounting Screws using
Phillips Screwdriver.
Install Slide Bar assembly over Mounting Brackets,
and secure with Set Screws using Flathead
Screwdriver.
RPG05-0888
22
1
8
“
562mm
3
“
76mm
3
1
4
“
83mm
3
“
76mm
25
“
635mm
3
5
8
“
92mm
2
3
8
“
60mm
M6 THREAD
SET SCREW
/