Simplay3 Company 416070-04, 416080-01, 416090-01, 416700-01, 416700-02 Owner's manual

  • Hello! I'm your chat assistant, and I've reviewed the user manual for the Simplay3 Mailbox. This document provides detailed instructions on how to assemble and install the mailbox, including important safety warnings, post requirements, decal application, and cleaning instructions. I'm ready to answer any questions you have about the installation process or the features of the mailbox.
  • What post size is required for installation?
    What is the recommended height for mailbox installation?
    What should be done before installing the mailbox?
1
Mailbox
ENGLISH
OBSERVE THE FOLLOWING STATEMENTS AND WARNINGS TO
REDUCE THE LIKELIHOOD OF SERIOUS OR FATAL INJURY.
SAVE THIS SHEET FOR FUTURE REFERENCE.
WARNING:
- Choking Hazard: Small parts. Sharp points. Adult assembly required.
- Required for Installation: Standard 4”x4” post cut to 48-inch length (not included)
- Note: with normal soil conditions and level ground, a standard 4”x4” post cut into 48 inch
length is adequate for mounting your Simplay3 Mailbox with 26 inches in ground and 22
inches above ground.
- Decal Application:
Clean and dry area thoroughly. Center decal in area. Apply pressure from center to
outer edge.
- To minimize risks posed by drill shavings, screws are designed to pierce the plastic
and form their own threads. Use caution not to over-tighten screws or they will not hold
parts together appropriately.
- Cleaning Instructions:
General Cleaning: Use mild soapy water.
- Disposal Instructions:
Please recycle when possible. Disposal must be in compliance with all government
regulations.
- USA Residents ONLY: CUSTOMERS ARE REQUIRED TO CONTACT THE LOCAL
POST OFFICE BEFORE INSTALLING THE MAILBOX TO ENSURE ITS CORRECT
PLACEMENT AND HEIGHT AT THE STREET. GENERALLY, MAILBOXES ARE INSTALLED
AT A HEIGHT OF 41-45 INCHES FROM THE ROAD SURFACE TO EITHER THE INSIDE
SURFACE OF THE MAILBOX THAT THE MAIL IS PLACED ON BY THE CARRIER OR TO
THE LOWEST EDGE OF MAIL ENTRY (FOR LOCKED MAIL SLOT DESIGNS) AND ARE
SET BACK 6-8 INCHES FROM THE FRONT FACE OF CURB OR ROAD EDGE TO THE
MAILBOX DOOR.
TOOLS REQUIRED
-Phillips Head
-Socket Wrench
PARTS LIST A
A
B
C
D E
x2
2 x 3” (7,62 CM)
6 x 2” (5,08 CM)
ASSEMBLY AND INSTALLATION INSTRUCTIONS
22”
4’ Ground Level
Above Ground
Below Ground
26”
A
Street
Note direction of
panel side
2 x 3” (7,62 CM)
| 56241610102
STYLES MAY VARY
Styles may vary
For assistance or replacement parts please contact Simplay3®
The Simplay3 Company
9450 Rosemont Drive
Streetsboro, OH 44241
| 1-866-855-0100
| www.simplay3.com
04/13/2018
1 2
3
The wood post should be approximately 22” above
ground. A 3/16” pilot hole may be drilled in post.
2
B
A
D
C
A
11. Decal Application
Peel and adhere your address to the recessed area on
either side of the mailbox. (It is recommended that you
adhere the numbers when the plastic is at average room
temperature).
| 56241610102 04/13/2018
4 5 6
7A
9A
A 1/8” pilot hole may be drilled in post.
10
7B 8
9B Flush
Flush Repeat to other side
Repeat to other side for part (E). Be sure to assemble door with ag facing the street.
4 x 2” (5,08 CM)
2 x 2” (5,08 CM)
/