Logik L16VCR10 User manual

Category
Vacuum cleaners
Type
User manual
Supply voltage: 230-240V~50Hz
Power input: 1200-1400W (1600W MAX)
Dust capacity: 2.5L
We continually strive to improve our products, specications may change without
prior notice.
GB - 4
This symbol on the product or in the instructions means that your electrical
and electronic equipment should be disposed at the end of its life separately
from your household waste. There are separate collection systems for
recycling in the EU.
For more information, please contact the local authority or your retailer
where you purchased the product.
GB - 5
DSG Retail Ltd. Maylands Avenue Hemel Hempstead Hertfordshire
HP2 7TG England
For your continued safety and to reduce the risk of injury or electric shock, please
follow all the safety precautions listed below.
• Read all the instructions carefully before using the appliance and keep them for
future reference.
• Retain the manual. If you pass the appliance onto a third party make sure to include
this manual.
• Check that the voltage marked on the rating label matches your mains voltage.
• Consult your dealer if you are ever in doubt about the installation, operation or safety
of your appliance.
• Do not remove any fixed cover as this may expose dangerous voltages.
• Do not allow electrical appliance to be exposed to dripping or splashing.
To protect against electrical shock, do not immerse mains cable, mains plug, or any
part of the appliance in water or other liquids.
• Make sure the dust bag is properly installed before use.
• Never vacuum up water or any other liquids. Never vacuum up flammable substances
and do not vacuum up ashes until they are cold.
• If a blockage is found in the brushes, hoses or tubes, it should be removed before use.
• Store and use the appliance well away from heat sources such as radiators or
gas/electric res.
• Do not run over the mains cable with the appliance.
• Close supervision is necessary when any appliance is used near children.
This appliance is not intended for use by persons (including children) with reduced
sensory or mental capabilities, or lack of experience and knowledge unless they have
been given supervision or instructions concerning the use of the appliance by a
person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Do not point the hose, tube or any other accessory at the eyes, ears or mouth during
operation.
• Unplug the appliance from the mains socket when it is not in use and before
replacing lter.
• Allow the appliance to cool completely before cleaning or storing.
• Do not use the appliance for other uses than its intended use.
The use of accessories not recommended by the appliance manufacturer may cause
injuries.
• Do not use the appliance outdoors.
• Do not operate an appliance with a damaged mains cable or mains plug, or in an
abnormal state. If the mains cable is damaged it must be replaced by the
manufacturer, its service agent, or similarly qualied persons in order to avoid a
hazard.
• Do not continue to operate the appliance if you are in any doubt about it working
normally (e.g. abnormal noise, smell, smoke), or if it is damaged in any way - switch
o, withdraw the mains plug and consult your dealer.
• Any maintenance and repair must be handled by a professional technician. Do not try
to repair by yourself.
Remove all packaging from the vacuum cleaner. Retain the packaging. If you dispose of it
please do so according to any local regulations.
The following items are included:
If items are missing or damaged, please contact Partmaster (UK only).
Tel: 0870 6001 338 for assistance.
• Main Unit • Hose
(P.N.: KPA07-H)
(P.N.: KPA07-C) (P.N.: KPA07-B) (P.N.: KPA07-I)
(P.N.: KPA07-T)
Telescopic Tube
• Combination Nozzle • Floor Brush • Instruction Manual
Visit Partmaster.co.uk today for the easiest way to buy
electrical spares and accessories. With over 1 million spares
and accessories available we can deliver direct to your door
the very next day. Visit www.partmaster.co.uk Or call 0870 6001 338 (UK customers only) Calls
charged at National Rate.
Bagged Cylinder
Vacuum Cleaner
Instruction Manual
L16VCR10
Congratulations
on the purchase of your
new Logik Vacuum Cleaner.
We recommend that you spend
some time to read this
Instruction Manual in order to
fully understand how to install
and operate it.
Read all the safety instructions
carefully before use and keep this
instruction manual for future
reference.
SPECIFICATIONS
SAFETY FIRST!
UNPACKING
GB - 1 GB - 2 GB - 3
1. Bin release button
2. Handle
3. Rear wheels
4. Hose connection opening
5. Bin
6. Dust release button
7. HEPA lter
8. Fine lter
9. ON/OFF button
10. Cord rewind button
11. Grill
12. Mains plug
13. Exhaust lter
14. Hose release button
15. Hose connector
16. Handgrip of hose
17. Hose
18. Handgrip
19. Wheel
20. Clip
21. Combination nozzle
22. Floor brush
23. Telescopic tube
23
22
21
17
15
14
16
18
20
19
10
11
12
13
9
1
2
3 4
5 6
7 8
9 10
11 12
1. To connect the hose, insert the hose connector into the hose connection
opening until you hear a click’ (Fig 1).
2. To connect the telescopic tubes to the handgrip of the hose, insert the narrow
section into the wider section while turning a little (Fig 2).
3. Extend the telescopic tube to a length you nd the most comfortable by
pressing the button located on the telescopic tube (Fig 3).
4. Connect a nozzle/brush suitable to the oor type to be cleaned. The oor brush
can be used with brush strips lowered or raised (Fig 4). You may also connect the
combination nozzle to vacuum corners, slots or grooves. It can also be used as a
brush nozzle by turning the brush out in the direction of the arrow (Fig 5).
1. Press the ON/OFF button on the top of the vacuum cleaner to turn it o and then
remove the mains plug from the mains socket.
2. Press the cord rewind button to rewind the retractable mains cable.
3. Put the vacuum cleaner in an upright position and attach the telescopic tube to the
clip on the vacuum cleaner (Fig 6).
Always unplug the vacuum cleaner from the mains socket before emptying the bin
and cleaning.
1. Remove the hose connector from the vacuum cleaner. Hold the bin handle and then
press the bin release button on the bin handle to take the bin out (Fig 7).
2. To prevent the dust dispersing, lower the bin into your dustbin, and then press the
dust release button to empty the bin (Fig 8).
3. If you nd the washable HEPA lter is blocked or dirty, remove the HEPA lter from
the bin by turning the HEPA lter anti-clockwise (Fig 9).
4. Remove the ne lter from the HEPA lter. Shake out the dust accumulated on the
HEPA lter. You may soak the lters in warm soapy water for a few minutes, and then
rinse them under a running tap to remove all traces of soap (Fig 10). Do not relocate
the lters until it they are completely dry.
5. Relocate the HEPA lter back into the bin by turning it clockwise. Do not over-
tighten it.
6. Relocate the bin back into the vacuum cleaner until you hear a click’.
Always unplug the appliance from mains socket before replacing the lter.
1. Unclip the grill and take out the exhaust lter (Fig 11 & Fig 12).
2. Shake out the dust accumulated on the lter into a dustbin.
3. Relocate the lter and the grill.
1. Hold the mains plug and pull the retractable mains cable out of the vacuum cleaner.
Connect the mains plug to the mains socket. The YELLOW mark indicates the ideal
length to extend the cable. Do not extend the mains cable beyond the RED mark
which indicates the maximum length.
2. Press the ON/OFF button on the top of the vacuum cleaner to turn it on.
3. To move the vacuum cleaner from room to room, you can unplug and carry it by either
the handle or the handgrip. Never use the mains cable to pull the vacuum cleaner.
4
3
1
2
5
7
6
8
PRODUCT OVERVIEW
PREPARATION BEFORE USE
OPERATION
POWERING OFF AND STORAGE
CLEANING THE EXHAUST FILTER
EMPTYING THE BIN AND CLEANING THE FILTERS
  • Page 1 1
  • Page 2 2

Logik L16VCR10 User manual

Category
Vacuum cleaners
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI