Cres Cor IFW 66 Installation guide

Type
Installation guide

Cres Cor IFW 66 is an infra red warmer with a 250-watt, 120-volt bulb that can be used to keep food warm. It is easy to install and can be mounted to an electrical outlet box with two screws. The warmer should be installed by an experienced electrician and must be at least 16” above a combustible surface. The Cres Cor IFW 66 is a versatile warmer that can be used in a variety of applications, such as:

  • Keeping food warm at a buffet or catered event
  • Thawing food quickly and safely
  • Keeping food warm in a kitchen or pantry
  • Providing heat to a small space, such as a bathroom or closet

Cres Cor IFW 66 is an infra red warmer with a 250-watt, 120-volt bulb that can be used to keep food warm. It is easy to install and can be mounted to an electrical outlet box with two screws. The warmer should be installed by an experienced electrician and must be at least 16” above a combustible surface. The Cres Cor IFW 66 is a versatile warmer that can be used in a variety of applications, such as:

  • Keeping food warm at a buffet or catered event
  • Thawing food quickly and safely
  • Keeping food warm in a kitchen or pantry
  • Providing heat to a small space, such as a bathroom or closet
INSTALLATION INSTRUCTIONS
IFW 66 SERIES INFRA RED WARMER
5925 Heisley Road • Mentor, OH 44060-1833
Decorator Hood
IFW 66 Series
FL-2194
Rev. 4 (05/06) Page 1 of 2
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
ELECTRICAL SPECS:
VOLTS WATTS AMPS HERTZ PHASE NEMA
120 250 2.0 60 1 5-15
240 275 1.1 60 1 6-15
Warmer should be installed by an experienced
electrician.
U.L. REQUIREMENTS:
A. Wires of warmers to be connected to 75°C wire.
B. Wires are to be installed in conduit.
C. Warmers are not to be installed any closer than 1” from
a wall.
D. Warmers must be at least 16” above a combustible
surface.
HOW TO INSTALL:
Numbers in parentheses correspond to numbers in callouts.
Remove the two screws from the canopy and pull off
the canopy.
Run the cord (1) up through the canopy, through the
strain relief and the threaded nipple. Tighten the strain
relief. Cut the cord to the desired length.
Mount the strap to the electrical outlet box with two
screws provided.
Wire the warmer leads to the outlet box leads.
Attach the ground wire to the ground hold in the strap
with the green ground screw.
Re-attach the canopy with the two screws.
Screw the bulb (4) into socket.
1.
2.
3.
4.
5.
6.
7.
INSTALLATION INSTRUCTIONS
IFW 66 SERIES INFRA RED WARMER
5925 Heisley Road • Mentor, OH 44060-1833
Decorator Hood
IFW 66 Series
FL-2194
Rev. 4 (05/06) Page 2 of 2
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
HOW TO INSTALL HOOD:
You will need a Phillips head (preferably magnetic)
screwdriver with a long neck.
Slide the hole in the top of the hood over the socket.
Look inside of the hood and line up two (2) hood
mounting holes with the holes in the arm assembly.
Put the screw provided on the screwdriver tip and
screw loosely into one hole and then into the other;
then tighten both screws.
Screw lamp into the socket.
1.
2.
3.
4.
REPLACEMENT PARTS:
ITEM DESCRIPTION PART NO.
1 Cord Assembly 0810-142
2 Socket Assembly 0822-037
3 Switch (120V) 0820-002
3 Switch (240V) 0808-122
4 Bulb, Red (120V) 0820-001
Bulb, White (120V) 0820-033
Bulb, Red (240V) 0820-014
  • Page 1 1
  • Page 2 2

Cres Cor IFW 66 Installation guide

Type
Installation guide

Cres Cor IFW 66 is an infra red warmer with a 250-watt, 120-volt bulb that can be used to keep food warm. It is easy to install and can be mounted to an electrical outlet box with two screws. The warmer should be installed by an experienced electrician and must be at least 16” above a combustible surface. The Cres Cor IFW 66 is a versatile warmer that can be used in a variety of applications, such as:

  • Keeping food warm at a buffet or catered event
  • Thawing food quickly and safely
  • Keeping food warm in a kitchen or pantry
  • Providing heat to a small space, such as a bathroom or closet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI