DO NOT RETURN TO THE STORE !
Visit www.dhpfurniture.com/eng/support-home
or call Toll-Free 1-800-267-1739
4070039
B34407003900 - 10125-M
Date of Purchase
Bridgeport Faux Leather Bed
E.L. - 2016-01-13
If parts are missing or damaged, we will gladly ship your
replacement parts free of charge.
Lot Number
Thank you for purchasing from DHP!
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY
INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
1
2014 Dorel Home Products All Rights Reserved
Full
Black
Weight Limit: 450 Lb / 204 Kg
Contact Us!
cs@dhpfurniture.com
DHP
410E, First Street South, Wright City, MO 63390, USA
Attention: Consumer Service.
Read Before Beginning Assembly
1-800-267-1739
Monday - Friday, 9:00 am - 5:00 pm (Eastern Time)
Warranty Information
2
B34407003900
Caution
DHP warrants this product to be free from defects in material and workmanship and
agrees to remedy any such defect. This warranty covers one year from the date of
original purchase. This is solely limited to the repair or replacement of defective
parts and assembly labor is not included.
This warranty does not apply to any product which has been improperly assembled,
subjected to misuse or abuse or which has been altered or repaired in any way.
Liability for consequential damages is excluded to the extent exclusion is permitted
by law. This warranty gives you specific legal rights and you may also have other
rights which vary from state to state.
To obtain warranty service, purchaser must present original bill of sale. Components
repaired or replaced are warranted through the remainder of the original warranty
period only. The defective components will be repaired or replaced without charge,
subject to the terms and conditions described above.
Visit www.dhpfurniture.com to view the limited warranty valid in the U.S. and
Canada.
Call our toll free number if you need assistance.
Work in a spacious area and near where the unit will be used, preferably on a
carpet, or use a piece of the cardboard packaging to protect your floor and product.
Recommended # of people needed for assembly: 2 (however it is always better
to have an extra hand). Estimated assembly time is 2 hours.
Make sure all parts are included. Most parts are labeled or stamped on the raw
edge.
Read each step carefully. It is very important that each step of the instructions is
performed in the correct order. If these steps are not followed in sequence,
assembly difficulties will occur.
This product is designed for home use and not intended for commercial use.
This product contains small components. Please ensure that they are kept away
from small children.
Do not use power tools to assemble your furniture. Power tools may strip or
damage the parts.
For help with assembly, identifying parts, product information or to order parts,
please contact us:
Page is loading ...
4
Parts
B34407003900
All in 1 big box!
Before you throw the package, please use the
Check Box to identify the parts and ensure that
you have all the parts needed for the assembly.
There are inner box(es) that include components
required to complete this assembly.
Replacement Parts, Visit www.dhpfurniture.com/eng/support-home
A
B
A1
C
D
J
I
H
G
F
P
N
M
L
K
Side Panel 01
T926860
X 2
Side Panel 02
T926870
X 2
Headboard
T935150
X 1
Back Panel
T935160
X 1
Footboard
T935170
X 1
Center Rail 02
T926710
X 1
Center Rail 01
T926700
X 2
Side Rail 02
T926680
X 4
Side Rail 01
T926670
X 2
Side Rail 03
T926690
X 2
Wooden Slats
T926770
X 24
Corner Bracket
T393110
X 4
Support Leg 02
T926660
X 2
Support Leg 01
T926730
X 2
Cross Brace
T927040
X 1
C
D
L
A1
B
C
D
A
F
G
G
H
I
J
M
P
K
S
T
X
Y
Z
Left Bracket
T393080
X 2
Right Bracket
T393090
X 2
Single Slat Cap
T926370
X 24
Double Slat Cap
T926380
X 12
Leg
T927950
X 4
T
Z
S
N
5
Hardware Pack
B34407003900
Hardware Pack #: T4028319-01
Hardware Note:
Please do not completely tighten all the hardware,
until the entire assembly is complete, unless
otherwise indicated in the step-by-step
instructions.
6
7
8
4
5
3
2
1
1/4" X 3/4"
X 44
1/4" X 1 3/8"
X 2
1/4" X 1 9/16"
X 28
1/4" X 1 3/4"
X 3
5/16" X 2 1/4"
X 4
5/16"
X 4
4mm
X 1
X 1
1/4"
X 3
9
6
B34407003900
Holes on part (F) should be facing upward.
Step 1
Attach (F)&(H) to (C)&(D) with BOLT 3.
Repeat the same step for remaining parts
(C) & (D).
X 16
3
C
D
H
F
F
H
D
C
7
B34407003900
Holes on part (G) should be facing upward.
Step 2
X 12
3
C
D
G
G
Attach (G) x 2 to previous subassembly
(C)&(D) with BOLT 3.
Repeat the same step for remaining
subassembly (C)&(D).
G
G
C
D
J
L
8
B34407003900
Step 3
X 12
1
S
T
C
D
Attach (S) to (D) and (T) to (C)with BOLT 1.
Repeat the same step for the other
subassembly (C) & (D).
T
C
S
D
9
B34407003900
Step 4
Stick (A1) to the back of (A) with Velcro as
illustrated.
A1
A
AN
10
B34407003900
Leave half of the bolts exposed!
Step 5
Screw BOLTS 1 into (A) & (B) and leave
half of the bolts exposed.
A
B
1
X 8
3
/
8
"
M
11
B34407003900
Step 6
Hang (C) & (D) on (A) & (B) as illustrated
below, don't completely tighten the BOLT
untill STEP 10 is complete.
A
C
C
D
D
C
B
A
AM
AM
12
B34407003900
Step 7
Push NUT 6 into the hole of the leg Z, then
attach (Z) to (N) with BOLT 5 and NUT 6.
Repeat this step for all remaining legs (Z).
X 4
X 4
5
N
Z
6
5
6
Z
Z
N
R
T
13
B34407003900
Step 8
8.1 Attach (N) x 4 to (A,B,C & D) with BOLT
1;
8.2 Attach (L) x 2 to (H) with BOLT 2.
X 2
A
D
C
B
L
H
N
C
D
A
C
N
1
L
2
H
2
X 16
1
8.1
8.2
14
B34407003900
Holes on part (I) & (J) should be facing up!
1
X 4
Slide (I) x 2 & (J) into (M) x 2, then fix them
with BOLT 1.
Step 9
I
I
J
M
M
U
15
B34407003900
Step 10
Attach subassembly from previous STEP to
(A) & (B) with BOLT 1, then properly tighten
all the bolts.
1
X 4
A
B
I
I
A
I
V
16
B34407003900
Attach (K) to (F) x 2 &(J) with BOLT 4 and
NUT 9 .
Step 11
X 3
4
J
K
F
9
4
F
K
X 3
9
AP
AR
AT
17
B34407003900
Step 12
12.1 Insert (P) into (X) ;
12.2 Press (X) into (F)&(G);
12.3 Repeat the same procedure for the
opposite side as shown.
P
G
F
G
X
P
X
P
X
P
F
X
F
12.1
12.2
12.3
AB
AC
AD
18
B34407003900
13.1
13.2
13.3
Y
I
Y
P
P
P
P
J
I
Insert both (P) into (Y), then press (Y) into
(I)&(J) as shown.
Step 13
J
Y
19
Helpful Hints
B34407003900
Move your new furniture carefully, with two
people lifting and carrying the unit to its new
location.
Your DHP furniture can be disassembled and
reassembled to move.
Some parts have been pre-assembled for this
item. They are illustrated on this page and available
for replacement.
WARNINGS:
For safety reasons and to prevent injuries:
This bed is not intended for use by children under 4
years old.
Prohibit jumping and horseplay on this bed.
Only use a mattress which is 74" - 75" long and 53"
- 54" wide.
Do not use risers under this bed.
Helpful Hints
Weight Limit: 450 Lb / 204 Kg
END CAP 01
T393100
X 16
END CAP 03
T393120
X 2
END CAP 04
T392520
X 2
END CAP 02
T920510
X 2
K
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/
