ASSEMBLY INSTRUCTIONS
Attach the T shaped connector (D) to the
assembled chair frame (B&C). Place chair
frame upside down on your non-abrasive
work surface, from upside insert a medium
bolt (Ga) through a lock washer (Ge), through
the rocker frame (B&C), through the connector (D)
through a large metal washer (Gf) and secure
with a large nut (Gh) for each hole. See Fig. 3.
Securely tighten the bolts.
1
2
3
3
ROCKER ASSEMBLY
Fig. 1
Fig. 2
Fig. 3
Place the sling seat and back (B) and the
rocker frame (C) on a flat surface. Align
the holes, from outside insert a long
bolt (Gc) through a small metal washer (Gd),
through the front crossbar of rocker
base (C), through the crossbar of seat
and back (B), through another small metal
washer (Gd) and secure with a small nut (Gg).
See Fig. 1. Do not tighten completely.
Repeat procedure for the other side.
Turn over the rocker frame (B&C). Line
up the holes, insert a short bolt (Gb)
through a small metal washer (Gd), through
the sling seat and back (B) and secure into
the rocker frame (C). See Fig. 2. Do not
tighten completely. Repeat procedure for
the other side. Securely tighten all bolts.
Gc
Gd
Gd
Gg
B
C
D
C
B
Gf
Gh
Ga
Ge
D
Gd
Gb