2. FLEXCO
  3. Roller Lacer Gold Class Lacer Head

FLEXCO Roller Lacer Gold Class Lacer Head Operating instructions

  • Hello! I've reviewed the provided installation instructions for the Flexco Gold Class Lacer Head. This document covers the step-by-step process of setting up the device including opening and removing rollers, positioning the head, adjustments and testing. I'm ready to assist you with any questions you have about the installation process or features of the lacer head.
  • What is the first step for installing the lacer head?
    What should be done after removing rollers?
    What is the purpose of the stabilizing wear clips?
Roller Lacer® Gold Class™ Lacer Head
Installation Instructions
Step 2 Step 3 Step 4
Step 5a Step 5b Step 5c
Step 6 Step 7
Step 1: Open rollers all the way by
turning the adjusting knob clockwise.
Step 2: Remove rollers.
Step 3: Position the head over the
access holes in the bottom pan.
Step 4: Break loose all four jam nuts
(top and bottom of head).
Step 5: Loosen top and bottom adjusting bolts until guide rollers clear extrusion channel (Step 5a - 5c).
Step 6: Remove head from extrusion. Step 7: If your lacer is equipped with
the stabilizing wear strip, remove and
discard it.
Step 8
Step 8: Install the four stabilizing
wear clips in position.
Step 14a Step 14b
Step 15
Step 11
Step 12
Step 10
Step 10: Place head back on
extrusion, positioning it so bottom
adjusting bolts are over the access
holes in bottom pan.
Step 11: Adjust the top bolts so that
the gap between head and extrusion
is equal.
Step 12: Finger tighten top and
bottom adjusting bolts.
Step 13: Test head for free movement
up and down the lacer extrusion.
If there is interference between
the sprocket and the extrusion,
repeat steps 10-12 until there is no
interference.
Step 14: Tighten the top and bottom
lock nuts.
Step 15: Reinstall rollers. While
turning the roller, tighten the nut until
the roller just starts to rub against the
extrusion. Now back nut off about ¼
to ½ turn.
Step 9
Step 9: If clevis bracket guide roller
assemblies were removed, reinstall
with the notch in the clevis bracket
positioned over and facing the roller
shaft.
Gap Equal
2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 • USA
Tel: (630) 971-0150 • Fax: (630) 971-1180 • E-mail: info@flexco.com
Visit www.flexco.com for other Flexco locations and products.
©2018 Flexible Steel Lacing Company. Roller Lacer® is a registered trademark of Flexible Steel
Lacing Company. 08/14/18. For reorder: X1534
/